Engineering Structures - October 2016

Published:	October 2016

Articles in this Issue

Author(s)	Title	Page(s)
De-la-Colina, Jaime / González-Pérez, Carlos A. / Valdés-González, Jesús	Accidental eccentricities, frame shear forces and ductility demands of buildings with uncertainties of stiffness and live load	113-127
Zhou, Xuhong / Liu, Jiepeng / Wang, Xuanding / Chen, Y. Frank	Behavior and design of slender circular tubed-reinforced-concrete columns subjected to eccentric compression	17-28
Camara, A. / Efthymiou, E.	Deck–tower interaction in the transverse seismic response of cable-stayed bridges and optimum configurations	494-506
Del Zoppo, Marta / Di Ludovico, Marco / Prota, Andrea	Deformation capacity of non-conforming r.c. columns under compressive axial load and biaxial bending	480-493
Yamazaki, Shinsuke / Usami, Tsutomu / Nonaka, Tetsuya	Developing a new hysteretic type seismic damper (BRRP) for steel bridges	286-301
Sivapathasundaram, Mayooran / Mahendran, Mahen	Development of fragility curves for localised pull-through failures of thin steel roof battens	64-84
Gribniak, Viktor / Pérez Caldentey, Alejandro / Kaklauskas, Gintaris / Rimkus, Arvydas / Sokolov, Aleksandr	Effect of arrangement of tensile reinforcement on flexural stiffness and cracking	418-428
Karalar, Memduh / Dicleli, Murat	Effect of thermal induced flexural strain cycles on the low cycle fatigue performance of integral bridge steel H-piles	388-404
Lai, Zhichao / Varma, Amit H.	Effective stress-strain relationships for analysis of noncompact and slender filled composite (CFT) members	457-472
Elias, Said / Matsagar, Vasant / Datta, T. K.	Effectiveness of distributed tuned mass dampers for multi-mode control of chimney under earthquakes	1-16
Patruno, L. / Ricci, M. / de Miranda, S. / Ubertini, F.	An efficient approach to the evaluation of wind effects on structures based on recorded pressure fields	207-220
Choi, Soomin / Kim, Yoon Young	Exact matching at a joint of multiply-connected box beams under out-of-plane bending and torsion	96-112
Adawi, Aiham / Youssef, Maged A. / Meshaly, Mohamed E.	Finite element modeling of the composite action between hollowcore slabs and the topping concrete	302-315
Tenchini, Andre / D'Aniello, Mario / Rebelo, Carlos / Landolfo, Raffaele / da Silva, Luís Simões / Lima, Luciano	High strength steel in chevron concentrically braced frames designed according to Eurocode 8	167-185
Bosco, M. / Ferrara, E. / Ghersi, A. / Marino, E. M. / Rossi, P. P.	Improvement of the model proposed by Menegotto and Pinto for steel	442-456
López-López, Andrés / Tomas, Antonio / Sánchez-Olivares, Gregorio	Influence of adjusted models of plastic hinges in nonlinear behaviour of reinforced concrete buildings	245-257
Soufeiani, Leila / Raman, Sudharshan N. / Jumaat, Mohd Zamin Bin / Alengaram, Ubagaram Johnson / Ghadyani, Ghasem / Mendis, Priyan	Influences of the volume fraction and shape of steel fibers on fiber-reinforced concrete subjected to dynamic loading – A review	405-417
Puystiens, Silke / Van Craenenbroeck, Maarten / De Laet, Lars / Van Hemelrijck, Danny / Van Paepegem, Wim / Mollaert, Marijke	Integrated analysis of kinematic form active structures for architectural applications: Design of a representative case study	376-387
Jin, Liu / Li, Dong / Du, Xiuli	Mechanical behavior and size effect of moderate high-strength RC columns under monotonic and cyclic axial compression	269-285
Zhang, Yanyang / Macorini, Lorenzo / Izzuddin, Bassam A.	Mesoscale partitioned analysis of brick-masonry arches	142-166
Versteijlen, W. G. / Metrikine, A. V. / van Dalen, K. N.	A method for identification of an effective Winkler foundation for large-diameter offshore wind turbine support structures based on in-situ measured small-strain soil response and 3D modelling	221-236
Zhou, Q. / Singh, M. P. / Huang, X. Y.	Model reduction and optimal parameters of mid-story isolation systems	36-48
Sarmiento, E. V. / Hendriks, M. A. N. / Geiker, M. R. / Kanstad, T.	Modelling the influence of the fibre structure on the structural behaviour of flowable fibre-reinforced concrete	186-195
Rojas, F. / Anderson, J. C. / Massone, L. M.	A nonlinear quadrilateral layered membrane element with drilling degrees of freedom for the modeling of reinforced concrete walls	521-538
Persson, P. / Persson, K. / Sandberg, G.	Numerical study on reducing building vibrations by foundation improvement	361-375
Mohamed, Nedal / Nehdi, Moncef L.	Rational finite element assisted design of precast steel fibre reinforced concrete pipes	196-206
Yang, Wei / Zheng, Shan-Suo / Zhang, De-Yi / Sun, Long-Fei / Gan, Chuan-Lei	Seismic behaviors of squat reinforced concrete shear walls under freeze-thaw cycles: A pilot experimental study	49-63
Tazarv, Mostafa / Saiidi, M. Saiid	Seismic design of bridge columns incorporating mechanical bar splices in plastic hinge regions	507-520
Areias, P. / Rabczuk, T. / César de Sá, J. / Alves, J. L.	Semi-implicit finite strain constitutive integration and mixed strain/stress control based on intermediate configurations	344-360
Bai, Li / Wadee, M. Ahmer	Slenderness effects in thin-walled I-section struts susceptible to local–global mode interaction	128-141
Zanuy, Carlos	Some remarks on the interaction of long-term effects in deflections of RC members	237-244
Christidis, Konstantinos I. / Vougioukas, Emmanouil / Trezos, Konstantinos G.	Strengthening of non-conforming RC shear walls using different steel configurations	258-268
Mimoto, Tatsuhiko / Sakaki, Takuya / Mihara, Takafumi / Yoshitake, Isamu	Strengthening system using post-tension tendon with an internal anchorage of concrete members	29-35
Hertelé, Stijn / Cosham, Andrew / Roovers, Paul	Structural integrity of corroded girth welds in vintage steel pipelines	429-441
Liu, Huijuan / Zhang, Wei / Yuan, Hao	Structural stability analysis of single-layer reticulated shells with stochastic imperfections	473-479
Pisani, Marco Andrea	Theoretical approach to the evaluation of the load-carrying capacity of the tie rod anchor system in a masonry wall	85-95
Guin, William E. / Wang, Jialai	Theoretical model of adhesively bonded single lap joints with functionally graded adherends	316-332
Madsen, Søren / Lange, Nis P. / Giuliani, Luisa / Jomaas, Grunde / Lazarov, Boyan S. / Sigmund, Ole	Topology optimization for simplified structural fire safety	333-343
Flaga, Andrzej / Kłaput, Renata / Augustyn, Marcin	Wind tunnel tests of two free-standing lighting protection masts in different arrangements with surroundings roof objects and roof conditions	539-548

About this
data sheet
IssueID
17947
Published on:
04/12/2018
Last updated on:
30/06/2019

Advertisement

Structurae cooperates with

International Association for Bridge and Structural Engineering (IABSE)

Advertisement

Engineering Structures - October 2016

Articles in this Issue

You have exceeded your monthly download limit!

Structurae Plus subscribers can download 30 media files or data sets per month.
Structurae Pro users are limited to 50.

Required Data

Engineering Structures - October 2016

Articles in this Issue

You have exceeded your monthly download limit! Structurae Plus subscribers can download 30 media files or data sets per month. Structurae Pro users are limited to 50.

Required Data

You have exceeded your monthly download limit!

Structurae Plus subscribers can download 30 media files or data sets per month.
Structurae Pro users are limited to 50.