Construction and Building Materials - June 2017

Published:	June 2017

Articles in this Issue

Author(s)	Title	Page(s)
Pickel, Daniel / Tighe, Susan / West, Jeffrey S.	Assessing benefits of pre-soaked recycled concrete aggregate on variably cured concrete	245-252
Ferreira, Eduardo Gurzoni Alvares / Yokaichiya, Fabiano / Rodrigues, Michelle S. / Beraldo, Antonio L. / Isaac, Augusta / Kardjilov, Nikolay / Franco, Margareth K. K. D.	Assessment of Greener Cement by employing thermally treated sugarcane straw ashes	343-352
He, An / Cai, Jian / Chen, Qing-Jun / Liu, Xinpei / Xue, Hua / Yu, Chenjie	Axial compressive behaviour of steel-jacket retrofitted RC columns with recycled aggregate concrete	501-516
Yan, Jia-Bao / Xie, Jian	Behaviours of reinforced concrete beams under low temperatures	410-425
Figueira, Rita B. / Sadovski, Andrei / Melo, Ana P. / Pereira, Elsa V.	Chloride threshold value to initiate reinforcement corrosion in simulated concrete pore solutions: The influence of surface finishing and pH	183-200
Sazedj, Soheyl / José Morais, António / Jalali, Said	Comparison of environmental benchmarks of masonry and concrete structure based on a building model	36-43
Bui, Rudy / Labat, Matthieu / Aubert, Jean-Emmanuel	Comparison of the Saturated Salt Solution and the Dynamic Vapor Sorption techniques based on the measured sorption isotherm of barley straw	140-151
Gao, Danying / Zhang, Lijuan / Nokken, Michelle	Compressive behavior of steel fiber reinforced recycled coarse aggregate concrete designed with equivalent cubic compressive strength	235-244
Jin, Liu / Zhang, Renbo / Du, Xiuli	Computational homogenization for thermal conduction in heterogeneous concrete after mechanical stress	222-234
Jiang, Chao / Gu, Xianglin / Huang, Qinghua / Zhang, Weiping	Deformation of concrete under high-cycle fatigue loads in uniaxial and eccentric compression	379-392
Guo, Tengteng / Wang, Chaohui / Yang, Xue / Sun, Xiaolong	Development and performance of sand fog seal with cooling and air purification effects	608-618
Lu, Cong / Leung, Christopher K. Y.	Effect of fiber content variation on the strength of the weakest section in Strain Hardening Cementitious Composites (SHCC)	253-258
Aghaeipour, Arash / Madhkhan, Morteza	Effect of ground granulated blast furnace slag (GGBFS) on RCCP durability	533-541
Li, Chenchen / Gao, Danying / Wang, Yinglai / Tang, Jiyu	Effect of high temperature on the bond performance between basalt fibre reinforced polymer (BFRP) bars and concrete	44-51
Guo, Meng / Bhasin, Amit / Tan, Yiqiu	Effect of mineral fillers adsorption on rheological and chemical properties of asphalt binder	152-159
Nahali, H. / Ben Mansour, H. / Dhouibi, L. / Idrissi, H.	Effect of Na 3 PO 4 inhibitor on chloride diffusion in mortar	589-597
Yang, Jianming / Tang, Qingqing / Wu, Qisheng / Li, Xiaohua / Sun, Zhixiang	The effect of seawater curing on properties of magnesium potassium phosphate cement	470-478
Hu, Xiaodi / Lei, Yong / Wang, Hainian / Jiang, Pei / Yang, Xu / You, Zhanping	Effect of tack coat dosage and temperature on the interface shear properties of asphalt layers bonded with emulsified asphalt binders	86-93
Yaphary, Yohannes L. / Yu, Zechuan / Lam, Raymond H. W. / Lau, Denvid	Effect of triethanolamine on cement hydration toward initial setting time	94-103
Sheng, Yanping / Zhang, Ben / Yan, Yu / Chen, Huaxin / Xiong, Rui / Geng, Jiuguang	Effects of phosphorus slag powder and polyester fiber on performance characteristics of asphalt binders and resultant mixtures	289-295
Chu, L. / Fwa, T. F. / Tan, K. H.	Evaluation of wearing course mix designs on sound absorption improvement of porous asphalt pavement	402-409
Messali, F. / Metelli, G. / Plizzari, G.	Experimental results on the retrofitting of hollow brick masonry walls with reinforced high performance mortar coatings	619-630
Albitar, M. / Ali, M. S. Mohamed / Visintin, P.	Experimental study on fly ash and lead smelter slag-based geopolymer concrete columns	104-112
Li, Maoyun / Wang, Hao / Xu, Guangji / Xie, Pengyu	Finite element modeling and parametric analysis of viscoelastic and nonlinear pavement responses under dynamic FWD loading	23-35
Zhang, Peiping / Huang, Jinqiu / Shen, Zhaopu / Wang, Xuelian / Luo, Feng / Zhang, Peng / Wang, Jian / Miao, Shiding	Fired hollow clay bricks manufactured from black cotton soils and natural pozzolans in Kenya	435-441
Tamburini, Sergio / Natali, Marco / Garbin, Enrico / Panizza, Matteo / Favaro, Monica / Valluzzi, Maria Rosa	Geopolymer matrix for fibre reinforced composites aimed at strengthening masonry structures	542-552
Le, Thang / Le Saout, Gwenn / Garcia-Diaz, Eric / Betrancourt, Damien / Remond, Sébastien	Hardened behavior of mortar based on recycled aggregate: Influence of saturation state at macro- and microscopic scales	479-490
Dulaimi, Anmar / Nageim, Hassan Al / Ruddock, Felicite / Seton, Linda	High performance cold asphalt concrete mixture for binder course using alkali-activated binary blended cementitious filler	160-170
Lafond, C. / Blanchet, P. / Galimard, P. / Landry, V. / Ménard, S.	Impact of a reinforcement treatment with acrylate impregnation on the mechanical behavior of black spruce as connector member	517-525
Al-Kheetan, Mazen J. / Rahman, Mujib M. / Chamberlain, Denis A.	Influence of early water exposure on modified cementitious coating	64-71
Hiremath, Parameshwar N. / Yaragal, Subhash C.	Influence of mixing method, speed and duration on the fresh and hardened properties of Reactive Powder Concrete	271-288
Behroozikhah, Abdolhamid / Morafa, Seyed Hasan / Aflaki, Sassan	Investigation of fatigue cracks on RAP mixtures containing Sasobit and crumb rubber based on fracture energy	526-532
Das, Aditya Kumar / Singh, Dharamveer	Investigation of rutting, fracture and thermal cracking behavior of asphalt mastic containing basalt and hydrated lime fillers	442-452
Kara, Çağdaş / Karacasu, Murat	Investigation of waste ceramic tile additive in hot mix asphalt using fuzzy logic approach	598-607
Meng, Dan / Huang, Ting / Zhang, Y. X. / Lee, C. K.	Mechanical behaviour of a polyvinyl alcohol fibre reinforced engineered cementitious composite (PVA-ECC) using local ingredients	259-270
Benkemoun, Nathan / Hammood, Mohammed Naji / Amiri, Ouali	A meso-macro numerical approach for crack-induced diffusivity evolution in concrete	72-85
Lors, C. / Ducasse-Lapeyrusse, J. / Gagné, R. / Damidot, D.	Microbiologically induced calcium carbonate precipitation to repair microcracks remaining after autogenous healing of mortars	461-469
Qiu, Qiwen / Lau, Denvid	A novel approach for near-surface defect detection in FRP-bonded concrete systems using laser reflection and acoustic-laser techniques	553-564
Golchin, Babak / Hamzah, Meor Othman / Mohd Hasan, Mohd Rosli	Optimization in producing warm mix asphalt with polymer modified binder and surfactant-wax additive	578-588
Shirzadi Javid, Ali Akbar / Arjmandi Nejad, Mohammad Ali	Packing density and surface finishing condition effects on the mechanical properties of various concrete pavements containing cement replacement admixtures	307-314
Lizárraga, José F. / Pérez-Gavilán, J. J.	Parameter estimation for nonlinear analysis of multi-perforated concrete masonry walls	353-365
Lin, Peng / Huang, Weidong / Tang, Naipeng / Xiao, Feipeng	Performance characteristics of Terminal Blend rubberized asphalt with SBS and polyphosphoric acid	171-182
Burroughs, Jedadiah F. / Shannon, Jay / Rushing, Todd S. / Yi, Kevin / Gutierrez, Quinn B. / Harrelson, Danny W.	Potential of finely ground limestone powder to benefit ultra-high performance concrete mixtures	335-342
Arifuzzaman, Md / Kim, Ho Sung	Prediction and evaluation of density and volume fractions for the novel perlite composite affected by internal structure formation	201-215
Han, Baoguo / Wang, Zhu / Zeng, Shuzhu / Zhou, Daocheng / Yu, Xun / Cui, Xia / Ou, Jinping	Properties and modification mechanisms of nano-zirconia filled reactive powder concrete	426-434
Khanzadeh Moradllo, Mehdi / Ley, M. Tyler	Quantitative measurement of the influence of degree of saturation on ion penetration in cement paste by using X-ray imaging	113-129
Liu, Meng / Dawood, Mina	Reliability analysis of adhesively bonded CFRP-to-steel double lap shear joint with thin outer adherends	52-63
Xu, Zhiqiang / Li, Weifeng / Sun, Jinfeng / Hu, Yueyang / Xu, Kai / Ma, Suhua / Shen, Xiaodong	Research on cement hydration and hardening with different alkanolamines	296-306
Zhu, Xingyi / Cai, Yongsheng / Zhong, Sheng / Zhu, Jun / Zhao, Hongduo	Self-healing efficiency of ferrite-filled asphalt mixture after microwave irradiation	12-22
Thomas, R. J. / Peethamparan, Sulapha	Stepwise regression modeling for compressive strength of alkali-activated concrete	315-324
Hadhood, Abdeldayem / Mohamed, Hamdy M. / Benmokrane, Brahim	Strength of circular HSC columns reinforced internally with carbon-fiber-reinforced polymer bars under axial and eccentric loads	366-378
Mehta, Ankur / Siddique, Rafat	Strength, permeability and micro-structural characteristics of low-calcium fly ash based geopolymers	325-334
Tan, Yongshan / Yu, Hongfa / Ma, Haiyan / Zhang, Yunqing / Wu, Chengyou	Study on the micro-crack evolution of concrete subjected to stress corrosion and magnesium sulfate	453-460
Arabzadeh, Ali / Ceylan, Halil / Kim, Sunghwan / Gopalakrishnan, Kasthurirangan / Sassani, Alireza / Sundararajan, Sriram / Taylor, Peter C.	Superhydrophobic coatings on Portland cement concrete surfaces	393-401
Huang, Jiankun / Liu, Wen / Shi, Zhifei	Surface-wave attenuation zone of layered periodic structures and feasible application in ground vibration reduction	1-11
Dassekpo, Jean-Baptiste Mawulé / Zha, Xiaoxiong / Zhan, Jiapeng	Synthesis reaction and compressive strength behavior of loess-fly ash based geopolymers for the development of sustainable green materials	491-500
Hosseini Balam, Nafise / Mostofinejad, Davood / Eftekhar, Mohamadreza	Use of carbonate precipitating bacteria to reduce water absorption of aggregates	565-577
Khamzin, Aleksey K. / Varnavina, Aleksandra V. / Torgashov, Evgeniy V. / Anderson, Neil L. / Sneed, Lesley H.	Utilization of air-launched ground penetrating radar (GPR) for pavement condition assessment	130-139
Huang, Puxi / Latif, Eshrar / Chang, Wen-Shao / Ansell, Martin P. / Lawrence, Mike	Water vapour diffusion resistance factor of Phyllostachys edulis (Moso bamboo)	216-221

About this
data sheet
IssueID
22620
Published on:
15/12/2018
Last updated on:
30/06/2019

Advertisement

Structurae cooperates with

International Association for Bridge and Structural Engineering (IABSE)

Advertisement

Construction and Building Materials - June 2017

Articles in this Issue

You have exceeded your monthly download limit!

Structurae Plus subscribers can download 30 media files or data sets per month.
Structurae Pro users are limited to 50.

Required Data

Construction and Building Materials - June 2017

Articles in this Issue

You have exceeded your monthly download limit! Structurae Plus subscribers can download 30 media files or data sets per month. Structurae Pro users are limited to 50.

Required Data

You have exceeded your monthly download limit!

Structurae Plus subscribers can download 30 media files or data sets per month.
Structurae Pro users are limited to 50.