Construction and Building Materials - Juni 2017

Erschienen:	Juni 2017

Artikel in dieser Ausgabe

Autor(en)	Titel	Seite(n)
Pickel, Daniel / Tighe, Susan / West, Jeffrey S.	Assessing benefits of pre-soaked recycled concrete aggregate on variably cured concrete	245-252
Ferreira, Eduardo Gurzoni Alvares / Yokaichiya, Fabiano / Rodrigues, Michelle S. / Beraldo, Antonio L. / Isaac, Augusta / Kardjilov, Nikolay / Franco, Margareth K. K. D.	Assessment of Greener Cement by employing thermally treated sugarcane straw ashes	343-352
He, An / Cai, Jian / Chen, Qing-Jun / Liu, Xinpei / Xue, Hua / Yu, Chenjie	Axial compressive behaviour of steel-jacket retrofitted RC columns with recycled aggregate concrete	501-516
Yan, Jia-Bao / Xie, Jian	Behaviours of reinforced concrete beams under low temperatures	410-425
Figueira, Rita B. / Sadovski, Andrei / Melo, Ana P. / Pereira, Elsa V.	Chloride threshold value to initiate reinforcement corrosion in simulated concrete pore solutions: The influence of surface finishing and pH	183-200
Sazedj, Soheyl / José Morais, António / Jalali, Said	Comparison of environmental benchmarks of masonry and concrete structure based on a building model	36-43
Bui, Rudy / Labat, Matthieu / Aubert, Jean-Emmanuel	Comparison of the Saturated Salt Solution and the Dynamic Vapor Sorption techniques based on the measured sorption isotherm of barley straw	140-151
Gao, Danying / Zhang, Lijuan / Nokken, Michelle	Compressive behavior of steel fiber reinforced recycled coarse aggregate concrete designed with equivalent cubic compressive strength	235-244
Jin, Liu / Zhang, Renbo / Du, Xiuli	Computational homogenization for thermal conduction in heterogeneous concrete after mechanical stress	222-234
Jiang, Chao / Gu, Xianglin / Huang, Qinghua / Zhang, Weiping	Deformation of concrete under high-cycle fatigue loads in uniaxial and eccentric compression	379-392
Guo, Tengteng / Wang, Chaohui / Yang, Xue / Sun, Xiaolong	Development and performance of sand fog seal with cooling and air purification effects	608-618
Lu, Cong / Leung, Christopher K. Y.	Effect of fiber content variation on the strength of the weakest section in Strain Hardening Cementitious Composites (SHCC)	253-258
Aghaeipour, Arash / Madhkhan, Morteza	Effect of ground granulated blast furnace slag (GGBFS) on RCCP durability	533-541
Li, Chenchen / Gao, Danying / Wang, Yinglai / Tang, Jiyu	Effect of high temperature on the bond performance between basalt fibre reinforced polymer (BFRP) bars and concrete	44-51
Guo, Meng / Bhasin, Amit / Tan, Yiqiu	Effect of mineral fillers adsorption on rheological and chemical properties of asphalt binder	152-159
Nahali, H. / Ben Mansour, H. / Dhouibi, L. / Idrissi, H.	Effect of Na 3 PO 4 inhibitor on chloride diffusion in mortar	589-597
Yang, Jianming / Tang, Qingqing / Wu, Qisheng / Li, Xiaohua / Sun, Zhixiang	The effect of seawater curing on properties of magnesium potassium phosphate cement	470-478
Hu, Xiaodi / Lei, Yong / Wang, Hainian / Jiang, Pei / Yang, Xu / You, Zhanping	Effect of tack coat dosage and temperature on the interface shear properties of asphalt layers bonded with emulsified asphalt binders	86-93
Yaphary, Yohannes L. / Yu, Zechuan / Lam, Raymond H. W. / Lau, Denvid	Effect of triethanolamine on cement hydration toward initial setting time	94-103
Sheng, Yanping / Zhang, Ben / Yan, Yu / Chen, Huaxin / Xiong, Rui / Geng, Jiuguang	Effects of phosphorus slag powder and polyester fiber on performance characteristics of asphalt binders and resultant mixtures	289-295
Chu, L. / Fwa, T. F. / Tan, K. H.	Evaluation of wearing course mix designs on sound absorption improvement of porous asphalt pavement	402-409
Messali, F. / Metelli, G. / Plizzari, G.	Experimental results on the retrofitting of hollow brick masonry walls with reinforced high performance mortar coatings	619-630
Albitar, M. / Ali, M. S. Mohamed / Visintin, P.	Experimental study on fly ash and lead smelter slag-based geopolymer concrete columns	104-112
Li, Maoyun / Wang, Hao / Xu, Guangji / Xie, Pengyu	Finite element modeling and parametric analysis of viscoelastic and nonlinear pavement responses under dynamic FWD loading	23-35
Zhang, Peiping / Huang, Jinqiu / Shen, Zhaopu / Wang, Xuelian / Luo, Feng / Zhang, Peng / Wang, Jian / Miao, Shiding	Fired hollow clay bricks manufactured from black cotton soils and natural pozzolans in Kenya	435-441
Tamburini, Sergio / Natali, Marco / Garbin, Enrico / Panizza, Matteo / Favaro, Monica / Valluzzi, Maria Rosa	Geopolymer matrix for fibre reinforced composites aimed at strengthening masonry structures	542-552
Le, Thang / Le Saout, Gwenn / Garcia-Diaz, Eric / Betrancourt, Damien / Remond, Sébastien	Hardened behavior of mortar based on recycled aggregate: Influence of saturation state at macro- and microscopic scales	479-490
Dulaimi, Anmar / Nageim, Hassan Al / Ruddock, Felicite / Seton, Linda	High performance cold asphalt concrete mixture for binder course using alkali-activated binary blended cementitious filler	160-170
Lafond, C. / Blanchet, P. / Galimard, P. / Landry, V. / Ménard, S.	Impact of a reinforcement treatment with acrylate impregnation on the mechanical behavior of black spruce as connector member	517-525
Al-Kheetan, Mazen J. / Rahman, Mujib M. / Chamberlain, Denis A.	Influence of early water exposure on modified cementitious coating	64-71
Hiremath, Parameshwar N. / Yaragal, Subhash C.	Influence of mixing method, speed and duration on the fresh and hardened properties of Reactive Powder Concrete	271-288
Behroozikhah, Abdolhamid / Morafa, Seyed Hasan / Aflaki, Sassan	Investigation of fatigue cracks on RAP mixtures containing Sasobit and crumb rubber based on fracture energy	526-532
Das, Aditya Kumar / Singh, Dharamveer	Investigation of rutting, fracture and thermal cracking behavior of asphalt mastic containing basalt and hydrated lime fillers	442-452
Kara, Çağdaş / Karacasu, Murat	Investigation of waste ceramic tile additive in hot mix asphalt using fuzzy logic approach	598-607
Meng, Dan / Huang, Ting / Zhang, Y. X. / Lee, C. K.	Mechanical behaviour of a polyvinyl alcohol fibre reinforced engineered cementitious composite (PVA-ECC) using local ingredients	259-270
Benkemoun, Nathan / Hammood, Mohammed Naji / Amiri, Ouali	A meso-macro numerical approach for crack-induced diffusivity evolution in concrete	72-85
Lors, C. / Ducasse-Lapeyrusse, J. / Gagné, R. / Damidot, D.	Microbiologically induced calcium carbonate precipitation to repair microcracks remaining after autogenous healing of mortars	461-469
Qiu, Qiwen / Lau, Denvid	A novel approach for near-surface defect detection in FRP-bonded concrete systems using laser reflection and acoustic-laser techniques	553-564
Golchin, Babak / Hamzah, Meor Othman / Mohd Hasan, Mohd Rosli	Optimization in producing warm mix asphalt with polymer modified binder and surfactant-wax additive	578-588
Shirzadi Javid, Ali Akbar / Arjmandi Nejad, Mohammad Ali	Packing density and surface finishing condition effects on the mechanical properties of various concrete pavements containing cement replacement admixtures	307-314
Lizárraga, José F. / Pérez-Gavilán, J. J.	Parameter estimation for nonlinear analysis of multi-perforated concrete masonry walls	353-365
Lin, Peng / Huang, Weidong / Tang, Naipeng / Xiao, Feipeng	Performance characteristics of Terminal Blend rubberized asphalt with SBS and polyphosphoric acid	171-182
Burroughs, Jedadiah F. / Shannon, Jay / Rushing, Todd S. / Yi, Kevin / Gutierrez, Quinn B. / Harrelson, Danny W.	Potential of finely ground limestone powder to benefit ultra-high performance concrete mixtures	335-342
Arifuzzaman, Md / Kim, Ho Sung	Prediction and evaluation of density and volume fractions for the novel perlite composite affected by internal structure formation	201-215
Han, Baoguo / Wang, Zhu / Zeng, Shuzhu / Zhou, Daocheng / Yu, Xun / Cui, Xia / Ou, Jinping	Properties and modification mechanisms of nano-zirconia filled reactive powder concrete	426-434
Khanzadeh Moradllo, Mehdi / Ley, M. Tyler	Quantitative measurement of the influence of degree of saturation on ion penetration in cement paste by using X-ray imaging	113-129
Liu, Meng / Dawood, Mina	Reliability analysis of adhesively bonded CFRP-to-steel double lap shear joint with thin outer adherends	52-63
Xu, Zhiqiang / Li, Weifeng / Sun, Jinfeng / Hu, Yueyang / Xu, Kai / Ma, Suhua / Shen, Xiaodong	Research on cement hydration and hardening with different alkanolamines	296-306
Zhu, Xingyi / Cai, Yongsheng / Zhong, Sheng / Zhu, Jun / Zhao, Hongduo	Self-healing efficiency of ferrite-filled asphalt mixture after microwave irradiation	12-22
Thomas, R. J. / Peethamparan, Sulapha	Stepwise regression modeling for compressive strength of alkali-activated concrete	315-324
Hadhood, Abdeldayem / Mohamed, Hamdy M. / Benmokrane, Brahim	Strength of circular HSC columns reinforced internally with carbon-fiber-reinforced polymer bars under axial and eccentric loads	366-378
Mehta, Ankur / Siddique, Rafat	Strength, permeability and micro-structural characteristics of low-calcium fly ash based geopolymers	325-334
Tan, Yongshan / Yu, Hongfa / Ma, Haiyan / Zhang, Yunqing / Wu, Chengyou	Study on the micro-crack evolution of concrete subjected to stress corrosion and magnesium sulfate	453-460
Arabzadeh, Ali / Ceylan, Halil / Kim, Sunghwan / Gopalakrishnan, Kasthurirangan / Sassani, Alireza / Sundararajan, Sriram / Taylor, Peter C.	Superhydrophobic coatings on Portland cement concrete surfaces	393-401
Huang, Jiankun / Liu, Wen / Shi, Zhifei	Surface-wave attenuation zone of layered periodic structures and feasible application in ground vibration reduction	1-11
Dassekpo, Jean-Baptiste Mawulé / Zha, Xiaoxiong / Zhan, Jiapeng	Synthesis reaction and compressive strength behavior of loess-fly ash based geopolymers for the development of sustainable green materials	491-500
Hosseini Balam, Nafise / Mostofinejad, Davood / Eftekhar, Mohamadreza	Use of carbonate precipitating bacteria to reduce water absorption of aggregates	565-577
Khamzin, Aleksey K. / Varnavina, Aleksandra V. / Torgashov, Evgeniy V. / Anderson, Neil L. / Sneed, Lesley H.	Utilization of air-launched ground penetrating radar (GPR) for pavement condition assessment	130-139
Huang, Puxi / Latif, Eshrar / Chang, Wen-Shao / Ansell, Martin P. / Lawrence, Mike	Water vapour diffusion resistance factor of Phyllostachys edulis (Moso bamboo)	216-221

Über diese
Datenseite
IssueID
22620
Veröffentlicht am:
15.12.2018
Geändert am:
30.06.2019

Anzeige

Structurae kooperiert mit

International Association for Bridge and Structural Engineering (IABSE)

Anzeige

Construction and Building Materials - Juni 2017

Artikel in dieser Ausgabe

Sie haben Ihr monatliches Download-Limit überschritten!

Structurae Plus-Abonnent·innen können 30 Medien bzw. Datensätze pro Monat herunterladen.
Structurae Pro-Nutzer·innen sind auf 50 beschränkt.

Pflichtangaben

Construction and Building Materials - Juni 2017

Artikel in dieser Ausgabe

Sie haben Ihr monatliches Download-Limit überschritten! Structurae Plus-Abonnent·innen können 30 Medien bzw. Datensätze pro Monat herunterladen. Structurae Pro-Nutzer·innen sind auf 50 beschränkt.

Pflichtangaben

Sie haben Ihr monatliches Download-Limit überschritten!

Structurae Plus-Abonnent·innen können 30 Medien bzw. Datensätze pro Monat herunterladen.
Structurae Pro-Nutzer·innen sind auf 50 beschränkt.