0
  • DE
  • EN
  • FR
  • International Database and Gallery of Structures

Advertisement

General Information

Completion: 1797
Status: out of service

Project Type

Structure: Tunnel
Function / usage: Canal tunnel

Location

Location: , , , ,
Coordinates: 52° 41' 55.40" N    2° 41' 4.79" W
Coordinates: 52° 42' 15.36" N    2° 41' 39.67" W
Show coordinates on a map

Technical Information

Dimensions

length 887.0 m

Excerpt from Wikipedia

Berwick Tunnel is a canal tunnel located on the Shrewsbury Canal, Shropshire, England, UK.

History

The Shrewsbury Canal connected Shrewsbury to the Wombridge Canal, and provided a way to supply the people of Shrewsbury with coal at reasonable prices. The route between Shrewsbury and Wappenshall was relatively flat, although beyond Wappenshall, nine locks and a large inclined plane were needed to reach the Wombridge Canal. There were two more locks before Wappenshall. The valleys of the River Tern and the River Roden were crossed by aqueducts, Longdon-on-Tern Aqueduct being, in Thomas Telford's opinion, the first aqueduct made of cast iron, although Benjamin Outram's iron aqueduct on the Derby Canal actually opened a month earlier. The other major obstacle to a level canal was a bluff of land near a large bend in the River Severn just to the east of Shrewsbury. A route closer to the river might have been possible and would have avoided a tunnel if a large landscaped park had not been created there in 1786, to the design of Humphry Repton.

Josiah Clowes was the engineer for the canal from the start of its construction until his death in 1795, and the tunnel was his design. However, William Reynolds, the iron founder responsible for the manufacture of the iron aqueduct, suggested that a towpath should be provided throughout its length. The tunnel was around 10 feet (3.0 m) wide, and the wooden towpath was fixed to bearers built into the wall. It was 3 feet (0.9 m) wide, but because the entire width of the tunnel was filled with water, including the bit below the towpath, the resistance to boats passing through the tunnel was reduced. The structure was 970 yards (890 m) long, and was the first tunnel to be constructed with a towpath. Tunnels without a towpath were arduous for the crews, as the boats had to be legged through them.

The tunnel runs in a south-easterly direction away from Shrewsbury, and passes under fields and a wood. The ground above it is fairly shallow, and there is a ventilation shaft near the middle. Most of the tunnel is lined with bricks, but both portals are faced with stone, and the south-east portal carries the date 1797 on the keystone. The towpath lasted until 1819, when it was removed. Because the tunnel was not straight, it was not possible to see if someone had entered the tunnel from the other end. To overcome this, a byelaw was introduced which stated that whoever reached the centre first should continue, whilst the other boat would have to turn back.

Today the canal is disused, and the tunnel remains, though the ends have been bricked up.

Text imported from Wikipedia article "Berwick Tunnel" and modified on 23 July 2019 under the CC-BY-SA 3.0 license.

Participants

Currently there is no information available about persons or companies having participated in this project.

Relevant Web Sites

  • About this
    data sheet
  • Structure-ID
    20067226
  • Published on:
    01/07/2015
  • Last updated on:
    03/06/2022
Structurae cooperates with
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine