Stresses in Saturated and Unsaturated Subgrade Layer Induced by Railway Track Vibration
Author(s): |
Mohammed Y. Fattah
Qutaiba G. Majeed Hasan H. Joni |
---|---|
Medium: | journal article |
Language(s): | English |
Published in: | Infrastructures, 9 April 2024, n. 4, v. 9 |
Page(s): | 64 |
DOI: | 10.3390/infrastructures9040064 |
Abstract: |
The theoretical and practical studies of the cyclic loads resulting from the movement and passage of trains on the unsaturated subgrade to determine the effect of the degree of saturation and moisture content on the foundations and infrastructure of the railway lines, especially the settlement in the railway lines as a result of the development of the train loads. Thirty-six laboratory experiments were carried out using models that simulate a railway with nearly half the scale of the real one, using an iron box of (1.5 × 1.0 × 1.0) meters and a layer of clay soil with a thickness of 0.5 m representing the base layer, were constructed inside it. Above it, there is a layer of crushed stone representing a 0.2 m thick ballast, topped by a rail line of 0.8 m long installed on three sleeper beams with dimensions of 0.9 m (0.1 × 0.1 m). The subgrade layer has been constructed at different saturation degrees as follows: 100, 80, 70, and 60%. The tests were carried out using different load amplitudes and frequencies. These experiments investigated the effect of the subgrade degree of saturation on the value of the stresses generated on the surface and the middle (vertical and lateral stresses) and the settlement of the subgrade. In the case of unsaturated subgrade soil, an increase in load frequency has a clear effect on increasing the generated stresses in the subgrade layer, especially with lower saturation levels. However, the results and measurements of these experiments found that the load frequency almost had no effect on the values of the stresses generated on the surface and inside the subgrade layer with a 100% degree of saturation. The results of the investigation demonstrated that, while load frequency had a minimal effect on track-panel settlement, it increased with the load amplitude and subgrade soil saturation degree. The change of settlement of the track panel with the number of cycles has a high rate at the beginning; after a while from that, it decreases gradually until, after some value of the number of cycles, the settlement changes at a very low rate and gradually. |
Copyright: | © 2024 the Authors. Licensee MDPI, Basel, Switzerland. |
License: | This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met. |
10.17 MB
- About this
data sheet - Reference-ID
10776408 - Published on:
29/04/2024 - Last updated on:
05/06/2024