Strength Formation and Failure Mechanism Analysis of Cement-Stabilized Laterite Granules Based on Numerical Simulation

The poor grading and significant differences in the mechanical properties of laterite granules in West Africa limit the application of this typical material in road structures. In this paper, the poorly graded laterite granule was blended with fine sand and stabilized with cement to improve the strength of laterite granules. An innovative combination of laboratory tests and numerical simulation analysis using the numerical simulation software PFC2D 5.0 was used to investigate the cement-stabilized laterite granule’s strength formation and failure mechanisms. Laboratory test results show that when the sand content is 40%, the grading curve is close to the maximum theoretical density lines (MTDLs), and the unconfined compressive strength of cement-stabilized laterite granules increased by 35.2% as the cement dosage increased from 2.5% to 5.0%. Numerical simulation tests show that the strength failure of cement-stabilized laterite granules is shear. The failure surface is tilted and through with the axial direction, and the compressive and tensile stresses between the particles cause the failure of the specimen. The simulation test results are close to the laboratory test results, and the deviation rate is less than 10%. It can guide the optimal grading design and strength prediction of cement-stabilized laterite granular materials and provides a basis for reducing laboratory tests and accurate design for such research in the future.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.