Stabilization and Recycling of Sand in Pedestrian Walkways

The production of construction and demolition waste (CDW) in urban areas is growing rapidly. While the storage and disposal of CDW waste is costly, its recovery can help to conserve natural resources. This study investigates the characteristics of recycled sand obtained from the processing of CDW waste and the possibility of its reuse for pedestrian pathways. Physico-chemical and mineralogical characteristics of the recycled sand were investigated for its reuse. The percentage of fine particles in sand (below 0.63 μm) is 2.8%. The grain size of sand fulfills the particle size requirement of French standards. The methylene blue value of sand is 0.05 g/100 g. The GTR classification of recycled sand is D2 which is insensitive to water and suitable for road applications. A mineralogical analysis of soil shows that quartz, albite and microcline are important minerals in recycled sand. XRF analysis shows that CaO and SiO2 are major oxides in the recycled sand. The characterization of sand was followed by a manufacturing of cylindrical specimens of sand to observe the compressive strength. Samples were compacted with dynamic compaction by applying the Proctor normal energy of 600 kN·m/m3. The compressive strength testing of specimens shows that non-stabilized sand samples have compressive strength around 0.1 MPa which is considerably lower for its reuse in pedestrian pathways and road applications. Due to the low bearing capacity of sand, recycled sand was stabilized with the addition of binders such as Rolac (hydraulic binder), ground-granulated blast furnace slag (GGBS) and ECOSOIL® (slag mixes) with different percentages of the binder ranging from 0 to 7% for the optimization of the binder and for economic efficiency. The compressive strength of sand samples increases with the increasing percentage of the binder. The increase in strength is more important with a higher percentage of binders (5%, 6% and 7%). At a 7% binder addition, specimens with Rolac, GGBS and ECOSOIL binders show the compressive strength of 1.2 MPa, 0.5 MPa and 0.5 MPa. At a 7% Rolac addition, specimens have a compressive strength higher than 1 MPa and meet the strength requirement for soil reuse in the foundation and subbase layers of roads with low traffic. The experimental work shows that recycled sand can replace conventional quarry sand for road applications and pathways with the addition of a local binder, which is an eco-friendly and economical practice.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.