SPH 코드를 사용한 TBM 디스크커터의 암석 절삭에 대한 수치해석적 연구 (A numerical study on rock cutting by a TBM disc cutter using SPH code)
| Author(s): |
Ho-Young Jeong
Seok-Won Jeon Jung-Woo Cho |
|---|---|
| Medium: | journal article |
| Language(s): | Korean |
| Published in: | Journal of Korean Tunnelling and Underground Space Association (한국터널지하공간학회 논문집), 2013, n. 3, v. 15 |
| Page(s): | 345-356 |
| DOI: | 10.9711/ktaj.2013.15.3.345 |
| Abstract: | Numerical simulation on rock cutting by a TBM disc cutter was carried out using SPH (Smoothed Particle Hydrodynamics) code. AUTODYN3D, a commercial software program based on finite element method, was used in this study. The three-dimensional geometry of a disc cutter and a rock specimen were modeled by Lagrange and SPH code respectively. The numerical simulation was carried out for Hwangdeung granite for 10 different cutting conditions. The results of the numerical simulation, i.e. the relation between cutter force and failure behavior, had a good agreement with those from LCM test. The cutter forces measured in the numerical simulation had 10% deviation from the LCM test results. Moreover, the optimum cutter spacing was almost identical with the experimental results. These results indicate that SPH code can be successfully used had applicability for simulation on rock cutting by a TBM disc cutter. However, further study on Lagrange-SPH coupled modelling would be necessary to reduce the computation time. |
- About this
data sheet - Reference-ID
10394742 - Published on:
04/01/2020 - Last updated on:
26/01/2020
Structurae cooperates with
