Seismic Performance Evaluation of Moment Resistance Connection by Load Velocity.
Author(s): |
Younghun Seol
(Pusan National University Busan Republic of Korea)
Kiwon Lee (DS Structural Engineering Co Busan Republic of Korea) Jaehan Park (Pusan National University Busan Republic of Korea) Sanghoon Oh |
---|---|
Medium: | journal article |
Language(s): | English |
Published in: | ce/papers, September 2023, n. 3-4, v. 6 |
Page(s): | 2310-2315 |
DOI: | 10.1002/cepa.2619 |
Abstract: |
The seismic performance of beam‐column connections is typically evaluated using a loading protocol specified by codes such as AISC. This protocol involves applying incremental and repeated loads at a specified speed to reach a target rotation angle, with a low load velocity of about 0.5 mm/s to 1.0 mm/s. However, testing at such a low load velocities may not fully account for brittleness breakdown due to factors such as a reduction in material toughness and a decrease in maximum deformation rate caused by stress concentration in vulnerable areas at high load velocities. Therefore, it is important to verify the seismic performance of connections, including their plastic deformation ability, under the influence of dynamic loads with high velocities, such as those experienced during an earthquake. We conducted a static and dynamic experiment on welded connections and extended end plate connections to analyze the effect of load velocity on connections behavior. Our results showed that increasing the load velocity reduced the strength of the connection, its plastic deformation capacity, and energy absorption capacity. These findings confirm that load velocity can significantly affect the seismic performance of connections and suggest that the current loading protocol may not fully capture the connection behavior under dynamic loads. |
- About this
data sheet - Reference-ID
10766847 - Published on:
17/04/2024 - Last updated on:
17/04/2024