Research on the Method of Absolute Stress Measurement for Steel Structures via Laser Ultrasonic

Accurate measurement of the stress in steel structures is crucial for structural health monitoring. To achieve this goal, a novel technique, the laser ultrasonic technique, was used in absolute stress measurement in this study. The feasibility of this technique has been verified through theoretical analysis and finite element (FE) analysis. A stress measurement experiment in steel specimens was conducted and the relationship between ultrasonic relative wave velocity and stress was explored. The results revealed that there is a similar linear correlation between the ultrasonic relative wave velocity and absolute stress. The stress can be obtained based on ultrasonic relative wave velocity. According to the stress measurement results, it was found that the absolute error between the measured stress and theoretical stress was largest when the stress level was low, and that the measured error of stress gradually decreased with increases in the applied stress. The relative error between the measured stress and the theoretical stress was within 10% when the stress was higher than 100 MPa. This further verifies the reliability of the laser ultrasonic technique under high-stress conditions. Additionally, the impact of temperature and surface roughness on stress measurement was analyzed. The stress error in stress measurement increased similarly linearly with the increase in temperature and increased non-linearly with the increase in roughness. The corresponding compensation methods were proposed to effectively improve the accuracy of measurement.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.