OC, HPC, UHPC and UHPFRC Corrosion Performance in the Marine Environment

This work aims to study the corrosion performance of six concretes in the marine environment: three ordinary concretes (C30, C40 and C50); one high-performance concrete (C90); two ultra high-performance concretes, one without fibres (C150-NF) and another one with steel fibres (C150-F). To this end, porosity and chloride ingress resistance were analysed at different ages. Resistivity was also evaluated and the corrosion rate in the embedded rebars was monitored. The results showed that C30, C40 and C50 had porosity accessible to water percentages and capillary absorption values between six- and eight-fold higher than C90 and C150-NF and C150-F, respectively. Similar differences were obtained when oxygen permeability was analysed. Chloride ingress resistance in the ordinary concretes was estimated to be one-fold lower than in C90 and two-fold lower than in C150-NF and C150-F. Presence of fibres in C150-F increased the diffusion coefficient between 5% and 50% compared to C150-NF. Fibres also affected resistivity: C150-NF had values above 5500 Ωm, but the C150-F and C90 values were between 700 and 1000 Ωm and were one-fold higher than the ordinary concretes. After 3 years, the corrosion damage in the embedded rebars exposed to a marine environment was negligible in C90, C150-NF and C150-F (9.5, 6.2 and 3.5 mg mass loss), but with higher values (between 170.4 and 328.9 mg) for C3, C40 and C50. The results allow a framework to be established to make comparisons in future studies.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.