0
  • DE
  • EN
  • FR
  • International Database and Gallery of Structures

Advertisement

Numerical Analysis of Shallow Foundations with Varying Loading and Soil Conditions

Author(s): ORCID
ORCID
ORCID

ORCID
ORCID
ORCID


Medium: journal article
Language(s): English
Published in: Buildings, , n. 5, v. 12
Page(s): 693
DOI: 10.3390/buildings12050693
Abstract:

The load–deformation relationship under the footing is essential for foundation design. Shallow foundations are subjected to changes in hydrological conditions such as rainfall and drought, affecting their saturation level and conditions. The actual load–settlement response for design and reconstructions is determined experimentally, numerically, or utilizing both approaches. Ssettlement computation is performed through large-scale physical modeling or extensive laboratory testing. It is expensive, labor intensive, and time consuming. This study is carried out to determine the effect of different saturation degrees and loading conditions on settlement shallow foundations using numerical modeling in Plaxis 2D, Bentley Systems, Exton, Pennsylvania, US. Plastic was used for dry soil calculation, while fully coupled flow deformation was used for partially saturated soil. Pore pressure and deformation changes were computed in fully coupled deformation. The Mohr–Columb model was used in the simulation, and model parameters were calculated from experimental results. The study results show that the degree of saturation is more critical to soil settlement than loading conditions. When a 200 KPa load was applied at the center of the footing, settlement was recored as 28.81 mm, which was less than 42.96 mm in the case of the full-depth shale layer; therefore, settlement was reduced by 30% in the underlying limestone rock layer. Regarding settlement under various degrees of saturation (DOS), settlment is increased by an increased degree of saturation, which increases pore pressure and decreases the shear strength of the soil. Settlement was observed as 0.69 mm at 0% saturation, 1.93 mm at 40% saturation, 2.21 mm at 50% saturation, 2.77 mm at 70% saturation, and 2.84 mm at 90% saturation of soil.

Copyright: © 2022 by the authors; licensee MDPI, Basel, Switzerland.
License:

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.

  • About this
    data sheet
  • Reference-ID
    10679519
  • Published on:
    18/06/2022
  • Last updated on:
    10/11/2022
 
Structurae cooperates with
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine