Исследование несущей способности свай на основе эмпирических данных, динамических испытаний и численного моделирования

Axial bearing capacity is an important factor in designing of foundation. It must be able to carry the load of upper structure without any significant deformation due to important role in pile design. A part from empirical and numerical methods, axial pile bearing capacity can be predicted by pile driving analyzer test that use wave equation analysis during the test. Prediction of the axial bearing capacity and its distribution can be achieved by combining wave equation analysis with dynamic pile monitoring. This paper compares the axial capacity of pile obtained from PDA records with predicted axial capacities obtained using empirical, numerical, and interpretation of static load test method. The empirical method used NSPT data from bore testing that conduct in site, finite element method that uses in this study is Plaxis 8.6. Both of them was compared with PDA test result of axial bearing capacity. There is a difference value of the calculation results of axial pile bearing capacity and foundation settlement. Comparing with PDA, from empirical method has smallest deviation for axial bearing capacity which equal to -268.45 kN with percentage -6.05%, smallest settlement equal to 0,0044 m. Plaxis result shows that distinction between Qult result equal to -11.00 kN with percentage -0.24% and settlement of foundation equal to 0,005 m. From interpretation of static loading test method smallest deviation for Qult which equal to -40,00 kN, with percentage -0,90%, and smallest settlement equal to 0,0055 m. So, from all method the smallest deviation for Qult and PDA result is used finite element method. This is due to many data parameters has been inputted and analyzed in the Plaxis program, so the results of calculation analysis are more detailed and closer to the situation in the research site. Differences in axial bearing capacity can be caused by the test was carried out which depends on the accuracy of operator and parameters that used in the calculations.