Investigation of the Insulation Effect of Thermal Insulation Layer in the Seasonally Frozen Region Tunnel: A Case Study in the Zuomutai Tunnel, China

In this study, a field temperature test was performed to reveal the insulation effect of the thermal insulation layer installed at lining surface. The thermal insulation layer is made of polyphenolic, and the thickness is 7 cm. According to the test results, the temperature of the thermal insulation layer and lining continuously changes with the air temperature in the tunnel in an approximately trigonometric function. The temperature of tunnel lining without thermal insulation layer is close to the air temperature, which results in the lining frost in winter. The maximum temperature difference between the two sides of the thermal insulation layer can be 27°C. In the section whose buried depth is more than 11.4 m, the temperature of lining with thermal insulation layer in winter is mainly influenced by the cold air in the tunnel. When the monthly mean and lowest daily mean air temperature are lower than −10°C and −14.3°C in the coldest month, the temperature at the inner side of the thermal insulation layer is below 0°C. When the buried depth is less than 11.4 m, the temperature of lining is also influenced by the low temperature at ground surface. The temperature of lining is lower. The thicker thermal insulation layer and even active heat measure are needed. Therefore, the design of thermal insulation layer thickness should consider the air temperature distribution and tunnel buried depth along the tunnel length.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.