0
  • DE
  • EN
  • FR
  • International Database and Gallery of Structures

Advertisement

The investigation of the energy harvesting performance using electrospun PTFE/PVDF based on a triboelectric assembly

Author(s): ORCID
ORCID

ORCID
ORCID
Medium: journal article
Language(s): English
Published in: Smart Materials and Structures, , n. 7, v. 33
Page(s): 075010
DOI: 10.1088/1361-665x/ad508d
Abstract:

This work presents an investigation into the energy harvesting performance of a combination of polytetrafluoroethylene (PTFE) and polyvinylidene fluoride (PVDF) materials prepared using a one-step electrospinning technique. Before electrospinning, different percentages of the 1 micron PTFE powder were added to a PVDF precursor. The surface morphology of the electrospun PTFE/PVDF fibre was investigated using a scanning electron microscope and tunnelling electron microscope. The structure was investigated using Fourier-transform infrared spectroscopy and x-ray diffraction analysis (XRD). A highly porous structure was observed with a mix of the α- and β-phase PVDF. The amount of β-phase was found to reduce when increasing the percentage of PTFE. The maximum amount of PTFE that could be added and still be successfully electrospun was 20%. This percentage showed the highest energy harvesting performance of the different PTFE/PVDF combinations. Electrospun fibres with different percentages of PTFE were deployed in a triboelectric energy harvester operating in the contact separation mode and the open circuit voltage and short circuit current were obtained at frequencies of 4–9 Hz. The 20% PTFE fibre showed 4 (51–202 V) and 7 times (1.3–9.04 µA) the voltage and current output respectively when compared with the 100% PVDF fibre. The V oc and I sc were measured for different load resistances from 1 kΩ to 6 GΩ and achieved a maximum power density of 348.5 mW m−2 with a 10 MΩ resistance. The energy stored in capacitors 0.1, 0.47, 1, and 10 µF from a book shaped PTFE/PVDF energy harvester were 1.0, 16.7, 41.2 and 136.8 µJ, respectively. The electrospun fibre is compatible with wearable and e-textile applications as it is breathable and flexible. The electrospun PTFE/PVDF was assembled into shoe insoles to demonstrate energy harvesting performance in a practical application.

Copyright: © 2024 Pattarinee White, Piyapong Pankaew, Dmitry Bavykin, M Moshrefi-Torbati, Stephen Beeby
License:

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.

  • About this
    data sheet
  • Reference-ID
    10783937
  • Published on:
    20/06/2024
  • Last updated on:
    20/06/2024
 
Structurae cooperates with
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine