Flexural behavior of beams strengthened with GFRP bars and high‐performance fiber‐reinforced concrete

The flexural behavior of beams strengthened with GFRP bars and high‐performance fiber‐reinforced concrete (HPFRC) was investigated in this paper. The four‐point flexural response of one reference beam and four beams strengthened with high‐performance fiber‐reinforced concrete was investigated by experimental research and theoretical calculation. The experimental and theoretical data (strain, load, etc.) are discussed. Parameters varied included the strengthening scheme (bottom‐side strengthening and three‐side strengthening) and the type of high‐performance fiber‐reinforced concrete (engineered cementitious composite [ECC] and ultra‐high‐performance concrete [UHPC]). The results showed that the cracking load and ultimate load of beams strengthened with UPFRC material were 31.3%–170% and 9.6%–20.7% higher, respectively, relative to the reference beam. Beams with three‐side strengthening (without interfacial debonding) had higher ultimate load, smaller crack width, and better durability relative to beams with bottom‐side strengthening. The UHPC layer was more effective in increasing the ultimate bearing capacity, and ECC strengthening layer was more effective in inhibiting cracking development of beams. Based on the experimental results, a model was proposed to predict the ultimate bearing capacity of beams strengthened with high‐performance fiber‐reinforced concrete, which could provide good agreement between the experimental and predicted results.