Experimental Study on the Physical and Mechanical Characteristics of Refractory Concrete Using Heat-Treated Steel Slag Coarse Aggregates

The aim of this study is to compare the properties of refractory concrete made with thermally treated and untreated steel slag. Five concrete compositions were prepared and investigated in the present work. The first mixture, referred to as the reference, was formulated using dolomite aggregates, whereas the second and third mixtures were developed by replacing natural coarse aggregate with 50 and 100% by weight of thermally untreated steel slag, respectively. The same replacement ratio (50% and 100%) of thermally treated steel slag was used to produce the fourth and fifth mixtures. Specimens of each specimen were placed in a furnace and heated to 400 °C and 800 °C. The mass loss for all the specimens heated to 400 °C was about 8%, while the reference suffered the maximum mass loss at 800 °C, which was 21.6%. The mixture with a 100% substitution of thermally treated steel slag produced the maximum compressive strength when compared to other mixtures at a temperature of 800 °C. The compressive strength of the M5 mixture was 18 MPa versus 10.87 MPa for the reference mixture. Additionally, optical microscope examination of specimens containing thermally treated steel slag revealed less damage than that observed in mixtures with dolomite.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.