Durchstanzwiderstand von Platten ohne Durchstanzbewehrung: Normenvergleich SIA 262:2013 zu DIN EN 1992-1-1:2004 + AC:2010

Punching shear resistance of slabs without transverse reinforcement: A comparison of the codes SIA 262:2013 and DIN EN 1992-1-1:2004 + AC:2010

Since 1 January 2013 in Switzerland, the revised code of the "SIA 262 Betonbau" has been in force. In the revised code the punching model has changed with regard to a few points when compared to the 2003 release. The model is formulated in a very detailed way and differs therefore significantly from the more simple approach of the Eurocode 2 (EC2). In the SIA 262, the punching shear resistance is based on a mechanical quantity, the rotation angle; in the EC2, it is largely based on a geometric quantity, the reinforcement ratio. Although the model of the SIA uses mechanical descriptions, additional empirical adaptions are inevitable because of the numerous factors which influence the punching shear resistance. Besides the different formulations, the distance of the control perimeter differs in both codes, which makes a comparison between them difficult.
This contribution outlines an inner column for the comparison of the two codes. Considered are the design procedure and the results for different input parameters. Therefore, the reinforcement ratio, the slab thickness and the column diameter are varied. Not considered are the influence of the concrete strength, the yield limit of the steel and the integrity reinforcement to avoid progressive collapse. Further investigations to these points and additional background can be found in the literature [4] and [5].
For comparison with the EC2, the nationally determined parameters (NDP) for Germany have been used. The NDP for Switzerland are not available because they are currently determined. It should be also mentioned that the NDP for Germany lead to smaller punching shear resistances than the recommended values of the EC2.