Alternative Method to the Replication of Wind Effects into the Buildings Thermal Simulation

To design energy-efficient buildings, energy assessment programs need to be developed for determining the inside air temperature, so that thermal comfort of the occupant can be sustained. The internal temperatures could be calculated through computational fluid dynamics (CFD) analysis; however, miniscule time steps (seconds and milliseconds) are used by a long-term simulation (i.e., weeks, months) that require excessive time for computing wind effects results even for high-performance personal computers. This paper examines a new method, wherein the wind effect surrounding the buildings is integrated with the external air temperature to facilitate wind simulation in building analysis over long periods. This was done with the help of an equivalent temperature (known as Tnatural), where the convection heat loss is produced in an equal capacity by this air temperature and by the built-in wind effects. Subsequently, this new external air temperature Tnatural can be used to calculate the internal air temperature. Upon inclusion of wind effects, above 90% of the results were found to be within 0–3 °C of the perceived temperatures compared to the real data (99% for insulated cavity brick (InsCB), 91% for cavity brick (CB), 93% for insulated reverse brick veneer (InsRBV) and 94% for insulated brick veneer (InsBV) modules). However, a decline of 83–88% was observed in the results after ignoring the wind effects. Hence, the presence of wind effects holds greater importance in correct simulation of the thermal performance of the modules. Moreover, the simulation time will expectedly reduce to below 1% of the original simulation time.

This creative work has been published under the Creative Commons Attribution 4.0 International (CC-BY 4.0) license which allows copying, and redistribution as well as adaptation of the original work provided appropriate credit is given to the original author and the conditions of the license are met.