Liang Wang 
- (2023): Exploring the risk propagation mechanisms of supply chain for prefabricated building projects. In: Journal of Building Engineering, v. 74 (September 2023).
- (2024): Investigating the hydration characteristics of iron tailings powder cement mortar produced by the mortar substitution method. In: Journal of Building Engineering, v. 81 (January 2024).
- (2023): Hygrothermal parameters measurement and building performance study of modified rammed earth materials. In: Energy and Buildings, v. 299 (November 2023).
- (2023): A novel bonded-type 3-degree-of-freedom ultrasonic motor: design, simulation, and experimental investigation. In: Smart Materials and Structures, v. 32, n. 6 (21 April 2023).
- (2022): Influence of Recycled Concrete Fines Content on the Dynamic Mechanical Properties of Coal Mine Roadway Support Mortar. In: KSCE Journal of Civil Engineering, v. 26, n. 11 (September 2022).
- (2022): Hydration, Compressive Strength and Durability of Eco-friendly Cement Mortars Containing Recycled Brick Powder and Metakaolin. In: KSCE Journal of Civil Engineering, v. 26, n. 9 (1 August 2022).
- (2022): Effect of nano-silica dispersed at different temperatures on the properties of cement-based materials. In: Journal of Building Engineering, v. 46 (April 2022).
- (2022): Jet-Grouting Technology for Reinforcement Strata Disturbance After Sand Mining. In: Frontiers in Built Environment, v. 8 (February 2022).
- (2022): A Novel Evaluation Method for the Stability of Construction Sites on an Abandoned Goaf: A Case Study. In: KSCE Journal of Civil Engineering, v. 26, n. 6 (April 2022).
- (2021): Low-cost, ubiquitous biomolecule as a strength enhancer for cement mortars. In: Construction and Building Materials, v. 311 (December 2021).
- (2021): Investigation on a novel bellows-type piezo-hydraulic actuator. In: Smart Materials and Structures, v. 30, n. 8 (June 2021).
- (2021): Exploring a comprehensive knowledge map for promoting safety management research in the construction industry. In: Engineering, Construction and Architectural Management, v. 29, n. 4 (May 2021).
- (2021): The Hydration and Compressive Strength of Cement Mortar Prepared by Calcium Acetate Solution. In: Advances in Civil Engineering, v. 2021 (January 2021).
- (2016): Modeling the Efficiency of the Iron Coprecipitation-Filtration Process for the Removal of Arsenate at Low Initial Concentrations. In: Journal of Environmental Engineering (ASCE), v. 142, n. 10 (October 2016).
- (2017): Experimental Investigation on the Thermal-Energy Storage Characteristics of the Subcritical Water. In: Journal of Energy Engineering, v. 143, n. 6 (December 2017).
- (2019): Effects of OFA Ratio on Coal Combustion and NOx Generation of a 600-MW Downfired Boiler after Changing Air Distribution around Fuel-Rich Flow. In: Journal of Energy Engineering, v. 145, n. 1 (February 2019).
- (2021): Exploring critical influencing factors for the site selection failure of waste-to-energy projects in China caused by the "not in my back yard" effect. In: Engineering, Construction and Architectural Management, v. 28, n. 6 ( 2021).
- (2021): Fracture analysis of corroded cold-formed thin steel plates based on actual morphology using micromechanical models. In: Construction and Building Materials, v. 267 (January 2021).
- (2020): Factors Influencing BIM Adoption for Construction Enterprises in China. In: Advances in Civil Engineering, v. 2020 (January 2020).
- (2021): Leaching behavior of copper and chromium in the mortar containing artificial fine aggregate prepared by contaminated soil. In: Construction and Building Materials, v. 270 (February 2021).
- (2019): A multiscale approach for virtual testing of highly aligned short carbon fiber composites. In: Composite Structures, v. 230 (December 2019).
- (2015): An experimental study on the effect of joining interface condition on bearing response of single-lap, countersunk composite-aluminum bolted joints. In: Composite Structures, v. 134 (December 2015).
- (2015): An experimental study on the effect of bolt-hole clearance and bolt torque on single-lap, countersunk composite joints. In: Composite Structures, v. 127 (September 2015).
- (2012): Experimental study on static characteristics of the bridge deck section under simultaneous actions of wind and rain. In: Journal of Wind Engineering and Industrial Aerodynamics, v. 107-108 (August 2012).
- (2018): Experimental Studies on CO₂ Absorption in Immersed Hollow Fiber Membrane Contactor. Presented at: 2012 International Conference on Civil, Architectural and Hydraulic Engineering (ICCAHE 2012), August 10-12th 2012, Zhangjiajie (China).
- (2017): An environmentally friendly method to improve the quality of recycled concrete aggregates. In: Construction and Building Materials, v. 144 (July 2017).
- (2019): Enhancing the performance of metakaolin blended cement mortar through in-situ production of nano to sub-micro calcium carbonate particles. In: Construction and Building Materials, v. 196 (January 2019).
- (2012): Experimental Study of Rain Effects on Vortex Shedding of Long Span Bridge Girders. In: Advances in Structural Engineering, v. 15, n. 10 (October 2012).
- (2016): A friction regulation hybrid driving method for backward motion restraint of the smooth impact drive mechanism. In: Smart Materials and Structures, v. 25, n. 8 (August 2016).
- (2018): A four-foot walking-type stepping piezoelectric actuator: driving principle, simulation and experimental evaluation. In: Smart Materials and Structures, v. 27, n. 11 (November 2018).
Structurae cooperates with
