Jeongsoo Nam 
- (2024): Alkali-Silica Reaction and Residual Mechanical Properties of High-Strength Mortar Containing Waste Glass Fine Aggregate and Supplementary Cementitious Materials. In: International Journal of Concrete Structures and Materials, v. 18, n. 1 (2 January 2024).
- (2024): ITZ properties of LWA surroundings in high strength mortar according to LWA/sand with relative humidity. In: Construction and Building Materials, v. 451 (November 2024).
- (2024): Investigation of Conditions for Using Mass-Produced Waste Glass as Sustainable Fine Aggregate for Mortar. In: International Journal of Concrete Structures and Materials, v. 18, n. 1 (2 January 2024).
- (2024): Monitoring long-term chloride penetration into wave power marine concrete structures under repeated air pressure. In: Construction and Building Materials, v. 428 (May 2024).
- (2024): Field experiment on performance of water source heat pump using underground rainwater tank as heat source. In: Journal of Building Engineering, v. 84 (May 2024).
- (2023): Characteristics on compressive strength and microstructure of high-strength cementitious composites with waste glass beads. In: Case Studies in Construction Materials, v. 19 (December 2023).
- (2023): Evaluation of mechanical properties and shielding effectiveness in mortar composites reinforced with waste aluminum alloy perforated sheets. In: Case Studies in Construction Materials, v. 19 (December 2023).
- (2019): Effect of moisture migration and water vapor pressure build-up with the heating rate on concrete spalling type. In: Cement and Concrete Research, v. 116 (February 2019).
- (2022): Effects of waste glass sand on the thermal behavior and strength of fly ash and GGBS based alkali activated mortar exposed to elevated temperature. In: Construction and Building Materials, v. 316 (January 2022).
- (2021): Impact resistance, flexural and tensile properties of amorphous metallic fiber-reinforced cementitious composites according to fiber length. In: Construction and Building Materials, v. 271 (February 2021).
- (2020): Influence of amorphous metallic fibers on spalling properties of high-strength concrete exposed to high temperature. In: Construction and Building Materials, v. 263 (December 2020).
- (2015): Static mechanical properties and impact resistance of amorphous metallic fiber-reinforced concrete. In: Composite Structures, v. 134 (December 2015).
- (2020): Effect of Mass Loss of Organic Fiber on the Water Vapor Pressure and Moisture Migration of 150 and 200 MPa Ultra-High Strength Concrete Exposed to High Temperature. In: Journal of Advanced Concrete Technology, v. 18, n. 6 (16 June 2020).
- (2018): Evaluation of concrete degradation depending on heating conditions by ultrasonic pulse velocity. In: Construction and Building Materials, v. 171 (May 2018).
- (2019): Effect of amorphous metallic fiber on mechanical properties of high-strength concrete exposed to high-temperature. In: Construction and Building Materials, v. 218 (September 2019).
- (2019): Shrinkage properties of concretes using blast furnace slag and frost-resistant accelerator. In: Construction and Building Materials, v. 220 (September 2019).
- (2016): Compressive strength, resistance to chloride-ion penetration and freezing/thawing of slag-replaced concrete and cementless slag concrete containing desulfurization slag activator. In: Construction and Building Materials, v. 128 (December 2016).
- (2017): Experimental Investigation on the Blast Resistance of Fiber-Reinforced Cementitious Composite Panels Subjected to Contact Explosions. In: International Journal of Concrete Structures and Materials, v. 11, n. 1 (February 2017).
Structurae cooperates with
