Mingxu Chen
- (2025): Effect of initial calcium to silicon ratio on the hybrid alkali-activated cement: From strength development to microstructure evolution. In: Construction and Building Materials, v. 464 (February 2025).
- (2024): Early age time-dependent mechanical properties of 3D-printed concrete with coarse aggregates. In: Construction and Building Materials, v. 451 (November 2024).
- (2024): Formulation and characterization of one-part Ca-based alkali-activated slag-steel slag materials. In: Construction and Building Materials, v. 449 (October 2024).
- (2024): Two-step approach to manufacture sustainable artificial steel slag aggregate used in alkali-activated concrete. In: Construction and Building Materials, v. 445 (September 2024).
- (2024): Rheology and buildability of sustainable 3D printed magnesium potassium phosphate cement composites incorporating MgO-SiO2-K2HPO4. In: Construction and Building Materials, v. 446 (October 2024).
- (2024): The adaptability of polycarboxylate superplasticizer in alkaline electrolyzed water (AEW)-based cement composites containing clay: Workability and mechanical properties. In: Construction and Building Materials, v. 444 (September 2024).
- (2024): Evaluation of combined addition of nitrite and chloride on the corrosion behavior of steel bars in modified magnesium oxysulfate cement paste. In: Construction and Building Materials, v. 422 (April 2024).
- (2023): Study of mix design and performance of alkali-activated concrete with recycled concrete aggregate. In: Construction and Building Materials, v. 400 (October 2023).
- (2021): Mix design and rheological properties of magnesium potassium phosphate cement composites based on the 3D printing extrusion system. In: Construction and Building Materials, v. 284 (May 2021).
- (2022): Recycling of waste oyster shell and recycled aggregate in the porous ecological concrete used for artificial reefs. In: Construction and Building Materials, v. 323 (March 2022).
- (2021): Printability and efflorescence control of admixtures modified 3D printed white Portland cement-based materials based on the response surface methodology. In: Journal of Building Engineering, v. 38 (June 2021).
- (2020): Effects of modified materials prepared from wastes on the performance of flue gas desulfurization gypsum-based composite wall materials. In: Construction and Building Materials, v. 257 (October 2020).
- (2020): Yield stress and thixotropy control of 3D-printed calcium sulfoaluminate cement composites with metakaolin related to structural build-up. In: Construction and Building Materials, v. 252 (August 2020).
- (2020): Rheological parameters and building time of 3D printing sulphoaluminate cement paste modified by retarder and diatomite. In: Construction and Building Materials, v. 234 (February 2020).
- (2019): Pore structure evolution and strength development of hardened cement paste with super low water-to-cement ratios. In: Construction and Building Materials, v. 227 (December 2019).
- (2019): Recycling of paper sludge powder for achieving sustainable and energy-saving building materials. In: Construction and Building Materials, v. 229 (December 2019).
- (2017): Investigation on the formation of tobermorite in calcium silicate board and its influence factors under autoclaved curing. In: Construction and Building Materials, v. 143 (July 2017).
- (2017): A case of water absorption and water/fertilizer retention performance of super absorbent polymer modified sulphoaluminate cementitious materials. In: Construction and Building Materials, v. 150 (September 2017).
- (2018): Rheological and mechanical properties of admixtures modified 3D printing sulphoaluminate cementitious materials. In: Construction and Building Materials, v. 189 (November 2018).
Structurae cooperates with
