General Information
Completion: | 1904 |
---|---|
Status: | in use |
Project Type
Structure: |
Single-span two-tower suspension bridge |
---|---|
Function / usage: |
Road bridge |
Location
Location: |
Riegelsville, Warren County, New Jersey, USA Riegelsville, Bucks County, Pennsylvania, USA |
---|---|
Crosses: |
|
Replaces: |
Riegelsville Bridge (1835)
|
Coordinates: | 40° 35' 39.12" N 75° 11' 26.88" W |
Technical Information
There currently is no technical data available.
Excerpt from Wikipedia
The Riegelsville Bridge is a suspension bridge crossing the Delaware River at Riegelsville, Pennsylvania, connecting it with Pohatcong Township, New Jersey, United States.
History
Traffic across the Delaware River at Riegelsville, Pennsylvania, was handled by Wendel and Anthony Shenk's oar powered ferries until December 15, 1837, when a three-span, wooden covered bridge was opened to horse, wagon, and pedestrian use. The Pennsylvania and New Jersey legislatures had approved the formation of the private Riegelsville Delaware Bridge Corporation in 1835 and the company engaged Solon Chapin and James Madison Porter of Easton, Pennsylvania as the contractors. A major flood struck the Delaware Valley on January 8, 1841, just three years after the bridge opened, and the span nearest the Jersey shore was destroyed. The bridge was repaired and survived another flood in June 1862.
The "Pumpkin Flood" occurred on October 10, 1903, and the Delaware waters rose to 33.8 feet (10.3 m) above normal. The two spans nearest to New Jersey were quickly swept down the river. The third section collapsed soon after.
The wire rope and engineering firm of John A. Roebling's Sons Co., based in Trenton, New Jersey, were soon commissioned and replaced the covered bridge with a cable suspension bridge. This new bridge incorporated the original piers which were repaired and raised several feet, allowing it to survive major damage from the flood of 1936 and to come through a 1955 deluge relatively unscathed. Together, the three spans are 585 feet (178 m) in length and the final cost of construction was $30,000. It opened on April 18, 1904.
Roebling's original design for the bridge employed main cables 2 5⁄8 inches (7 cm) in diameter. Professor James Madison Porter III, the grandson of the builder of the earlier Riegelsville bridge, was asked to evaluate the new design and felt the need for additional cables of 1 3⁄4 inches (4 cm) diameter, which were added to the plans.
The Riegelsville suspension bridge collected tolls until it was purchased by the Joint Commission for Eliminating Tolls and is currently maintained by the Delaware River Joint Toll Bridge Commission using revenues generated from larger, more heavily trafficked crossings. The bridge has a 3-ton weight limit.
Text imported from Wikipedia article "Riegelsville Bridge" and modified on July 23, 2019 according to the CC-BY-SA 4.0 International license.
Participants
Relevant Web Sites
- About this
data sheet - Structure-ID
20005820 - Published on:
02/10/2002 - Last updated on:
05/02/2016