Energy and Buildings - janvier 2016

Publié:	janvier 2016

Articles dans ce numéro

Auteur(s)	Titre	Page(s)
Berger, Julien / Mazuroski, Walter / Mendes, Nathan / Guernouti, Sihem / Woloszyn, Monika	2D whole-building hygrothermal simulation analysis based on a PGD reduced order model	49-61
Ihara, Takeshi / Jelle, Bjørn Petter / Gao, Tao / Gustavsen, Arild	Accelerated aging of treated aluminum for use as a cool colored material for facades	184-197
Candanedo, Luis M. / Feldheim, Véronique	Accurate occupancy detection of an office room from light, temperature, humidity and CO 2 measurements using statistical learning models	28-39
Hoffmann, Sabine / Lee, Eleanor S. / McNeil, Andrew / Fernandes, Luis / Vidanovic, Dragan / Thanachareonkit, Anothai	Balancing daylight, glare, and energy-efficiency goals: An evaluation of exterior coplanar shading systems using complex fenestration modeling tools	279-298
Nijhuis, M. / Gibescu, M. / Cobben, J. F. G.	Bottom-up Markov Chain Monte Carlo approach for scenario based residential load modelling with publicly available data	121-129
Năstase, Gabriel / Şerban, Alexandru / Dragomir, George / Bolocan, Sorin / Brezeanu, Alin Ionuţ	Box window double skin façade. Steady state heat transfer model proposal for energetic audits	12-20
Killian, M. / Mayer, B. / Kozek, M.	Cooperative fuzzy model predictive control for heating and cooling of buildings	130-140
Hitchin, Roger / Knight, Ian	Daily energy consumption signatures and control charts for air-conditioned buildings	101-109
Melo, A. P. / Fossati, M. / Versage, R. S. / Sorgato, M. J. / Scalco, V. A. / Lamberts, R.	Development and analysis of a metamodel to represent the thermal behavior of naturally ventilated and artificially air-conditioned residential buildings	209-221
Jeong, Su-Gwang / Chang, Seong Jin / Wi, Seunghwan / Kang, Yujin / Kim, Sumin	Development and performance evaluation of heat storage paint with MPCM for applying roof materials as basic research	62-68
Saffari, Mohammad / de Gracia, Alvaro / Ushak, Svetlana / Cabeza, Luisa F.	Economic impact of integrating PCM as passive system in buildings using Fanger comfort model	159-172
Grolinger, Katarina / L'Heureux, Alexandra / Capretz, Miriam A. M. / Seewald, Luke	Energy Forecasting for Event Venues: Big Data and Prediction Accuracy	222-233
Taniguchi, Ayako / Inoue, Takuya / Otsuki, Masaya / Yamaguchi, Yohei / Shimoda, Yoshiyuki / Takami, Akinobu / Hanaoka, Kanako	Estimation of the contribution of the residential sector to summer peak demand reduction in Japan using an energy end-use simulation model	80-92
Colinart, T. / Lelievre, D. / Glouannec, P.	Experimental and numerical analysis of the transient hygrothermal behavior of multilayered hemp concrete wall	1-11
Wu, Xiaozhou / Olesen, Bjarne W. / Fang, Lei / Zhao, Jianing / Wang, Fenghao	Indoor temperatures for calculating room heat loss and heating capacity of radiant heating systems combined with mechanical ventilation systems	141-148
Pisello, A. L. / Fortunati, E. / Mattioli, S. / Cabeza, L. F. / Barreneche, C. / Kenny, J. M. / Cotana, F.	Innovative cool roofing membrane with integrated phase change materials: Experimental characterization of morphological, thermal and optic-energy behavior	40-48
Biswas, Kaushik / Shrestha, Som S. / Bhandari, Mahabir S. / Desjarlais, Andre O.	Insulation materials for commercial buildings in North America: An assessment of lifetime energy and environmental impacts	256-269
Vasilyev, G. P. / Tabunshchikov, Iu A. / Brodach, M. M. / Leskov, V. A. / Mitrofanova, N. V. / Timofeev, N. A. / Gornov, V. F. / Esaulov, G. V.	Modeling moisture condensation in humid air flow in the course of cooling and heat recovery	93-100
Saloux, E. / Sorin, M. / Teyssedou, A.	Modeling the exergy performance of heat pump systems without using refrigerant thermodynamic properties	69-79
Zeng, Rong / Li, Hongqiang / Jiang, Runhua / Liu, Lifang / Zhang, Guoqiang	A novel multi-objective optimization method for CCHP–GSHP coupling systems	149-158
Calcerano, Filippo / Martinelli, Letizia	Numerical optimisation through dynamic simulation of the position of trees around a stand-alone building to reduce cooling energy consumption	234-243
Di Pilla, L. / Desogus, G. / Mura, S. / Ricciu, R. / Di Francesco, M.	Optimizing the distribution of Italian building energy retrofit incentives with Linear Programming	21-27
Khoury, J. / Mbayed, R. / Salloum, G. / Monmasson, E.	Predictive demand side management of a residential house under intermittent primary energy source conditions	110-120
Zhang, Zhengyan / Wang, Bo	Research on the life-cycle CO 2 emission of China's construction sector	244-255
Wu, Ting / Lei, Chengwang	A review of research and development on water wall for building applications	198-208
Shen, Chong / Li, Xianting	Solar heat gain reduction of double glazing window with cooling pipes embedded in venetian blinds by utilizing natural cooling	173-183
Hu, Yunpeng / Chen, Huanxin / Li, Guannan / Li, Haorong / Xu, Rongji / Li, Jiong	A statistical training data cleaning strategy for the PCA-based chiller sensor fault detection, diagnosis and data reconstruction method	270-278

Informations
sur cette fiche
IssueID
38618
Publié(e) le:
27.10.2020
Modifié(e) le:
09.05.2022

Publicité

Structurae coopère avec

International Association for Bridge and Structural Engineering (IABSE)

Publicité

Energy and Buildings - janvier 2016

Articles dans ce numéro

Vous avez dépassé votre limite de téléchargement mensuelle !

Les abonné·es à Structurae Plus peuvent télécharger 30 images ou ensembles de données par mois.
Les utilisateurs·rices de Structurae Pro sont limités à 50.

Données obligatoires

Energy and Buildings - janvier 2016

Articles dans ce numéro

Vous avez dépassé votre limite de téléchargement mensuelle ! Les abonné·es à Structurae Plus peuvent télécharger 30 images ou ensembles de données par mois. Les utilisateurs·rices de Structurae Pro sont limités à 50.

Données obligatoires

Vous avez dépassé votre limite de téléchargement mensuelle !

Les abonné·es à Structurae Plus peuvent télécharger 30 images ou ensembles de données par mois.
Les utilisateurs·rices de Structurae Pro sont limités à 50.