0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

Simulation of four-point beam bending test using the X-FEM method

Auteur(s):

Médium: article de revue
Langue(s): anglais
Publié dans: Budownictwo i Architektura, , n. 3, v. 19
Page(s): 057-067
DOI: 10.35784/bud-arch.2143
Abstrait:

This article presents the results of the computer simulations of a four-point bending test of a concrete single-edge notched beam. In this publication, the authors compared the X-FEM method of simulating the crack in the Abaqus FEA system. The paper also contains the results obtained with the Abaqus subroutine recently developed by the authors, used for defining the direction of the crack and the failure criterion. The publication explains the way of working of this algorithm. The described calculations show that computer analysis gives unrealistic results in terms of the destructive force. SEN-beam is an interesting laboratory test in which a lot of factors influence the results. It is especially important to study what phenomena occur in the final phase of the study, when the crack tip is near the opposite side.

License:

Cette oeuvre a été publiée sous la license Creative Commons Attribution - Partage dans les Mêmes Conditions 4.0 (CC-BY-SA 4.0) International. Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et que le partage se fait dans les mêmes conditions (license) que l'original. Un lien vers la license (ci-dessus) toit être inclus. Toute altération vis-à-vis de l'original doit être indiquée.

  • Informations
    sur cette fiche
  • Reference-ID
    10475546
  • Publié(e) le:
    13.11.2020
  • Modifié(e) le:
    02.06.2021
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine