Minimum Flexural Reinforcement Steel Ratios of High-Strength Concrete Beams

Considering that most studies depend on theoretical equations to determine the minimum reinforcement ratio, only a few studies on this ratio are available. Therefore, a more defined limit should be suggested to design codes by performing additional investigations and experimental studies on this limit. This study examines the behavior of high-strength concrete (HSC) beams with low reinforcing steel ratios to establish a limit for the lowest flexural reinforcement ratio that will ensure ductility. Experiments were performed on 12 reinforced HSC beams with a concrete compressive strength of 99 MPa, which were divided into three categories depending on their size. Each category comprised four beam reinforcement ratios (0%, 0.13%, 0.33%, and 0.65%), and two main parameters (beam size and reinforcement ratio) were investigated. Furthermore, to ensure flexural failure at the middle-span, adequate web reinforcing was used in all the beams and tested under a four-point load until they exhibited failure. Based on regression analysis, an equation was proposed for the rupture modulus of reinforced beams. The findings suggest that, in addition to the yielding strength of the reinforcements and the compressive strength of the concrete, the depth of the beams should be considered when computing the minimum flexural reinforcement of beams.

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.