A repair and retrofitting intervention to improve plastic dissipation and shear strength of Chinese rc bridges
|
|
|||||||||||
Détails bibliographiques
| Auteur(s): |
Davide Lavorato
(Dept. of Architecture, Roma Tre University, Largo G. B. Marzi, 10, Roma, Italy.)
Silivia Santini (Dept. of Architecture, Roma Tre University, Largo G. B. Marzi, 10, Roma, Italy.) Camillo Nuti 
(Dept. of Architecture, Roma Tre University, Largo G. B. Marzi, 10, Roma, Italy.)
Bruno Briseghella
(Dept. of Civil Engineering, Fuzhou University, Fujian, China.)
Junqing Xue (Dept. of Civil Engineering, Fuzhou University, Fujian, China.) |
||||
|---|---|---|---|---|---|
| Médium: | papier de conférence | ||||
| Langue(s): | anglais | ||||
| Conférence: | IABSE Conference: Structural Engineering: Providing Solutions to Global Challenges, Geneva, Switzerland, September 2015 | ||||
| Publié dans: | IABSE Conference Geneva 2015 | ||||
|
|||||
| Page(s): | 1762-1767 | ||||
| Nombre total de pages (du PDF): | 6 | ||||
| Année: | 2015 | ||||
| DOI: | 10.2749/222137815818359249 | ||||
| Abstrait: |
In this paper a rapid repair and retrofitting technique for reinforced concrete (rc) Chinese bridges damaged by a strong earthquake, is proposed and tested. This intervention is an upgrade of the one tested with very good results during a previous experimental research on bridges designed according to the old Italian code without proper seismic details. The improvement of the repair operation consists in the use of dissipation systems to substitute the damaged rebar parts at pier base guaranteeing the correct plastic distribution in plastic hinge only. Dissipation systems with different configurations were considered to optimize the intervention. The repaired and retrofitted Italian bridge already studied in the previous research, was designed according to Chinese codes but with insufficient transversal steel reinforcement. Some pier specimens (scale 1:6) of the most stressed pier of this bridge, with and without dissipation systems, were built. A C- FRP wrapping was applied to increase the insufficient shear strength and the ductility in plastic hinge. Cyclic tests were carried out on the scaled specimens at Fuzhou University lab (China) to evaluate the effectiveness of the proposed technique. |
||||
