Lateral torsional buckling of plate girder composite bridges – general method
|
|
|||||||||||
Détails bibliographiques
| Auteur(s): |
Stoyan Ivanov
(University of Architecture, Civil Engineering and Geodesy & Schimetta Consult Engineering Ltd., Sofia, Bulgaria)
|
||||
|---|---|---|---|---|---|
| Médium: | papier de conférence | ||||
| Langue(s): | anglais | ||||
| Conférence: | IABSE Congress: Structural Engineering for Future Societal Needs, Ghent, Belgium, 22-24 September 2021 | ||||
| Publié dans: | IABSE Congress Ghent 2021 | ||||
|
|||||
| Page(s): | 675-681 | ||||
| Nombre total de pages (du PDF): | 7 | ||||
| DOI: | 10.2749/ghent.2021.0675 | ||||
| Abstrait: |
According to Eurocode 4-2, lateral torsional buckling check should be performed for any steel flange in compression that is not laterally restrained. In common steel-concrete composite bridges, with slab on top of the main girders and no additional horizontal bracing, this applies for the bottom flanges over internal supports of a continuous beams. The check is also relevant for the bottom flanges at the abutments of integral composite bridges. Eurocode 4-2 gives recommendations for the use of three verification methods for LT buckling: Inverted U-frame method, General method, and Simplified method. In this paper the three methods are discussed. Their restrictions for practical application are commented. Application of the General and Simplified methods over a single span integral composite bridge is illustrated. Comparison of the results between the General method and the Simplified method is presented. |
||||
| Mots-clé: |
méthode générale ponts mixtes acier-béton
|
||||
| Copyright: | © 2021 International Association for Bridge and Structural Engineering (IABSE) | ||||
| License: | Cette oeuvre ne peut être utilisée sans la permission de l'auteur ou détenteur des droits. |
||||