Seismic Design of a Typical Mid-Rise Residential Building in Serbia Using Confined Masonry and Reinforced Concrete Frame Systems

Masonry has been widely used for the construction of residential buildings in Serbia and the majority of European countries. Confined masonry (CM) is a contemporary masonry technology that consists of load-bearing masonry walls enclosed in lightly reinforced horizontal and vertical reinforced concrete (RC) confining elements. CM has been widely used for the construction of low-rise and mid-rise residential buildings in Serbia and the region (Yugoslavia) since the 1960s. The design case study of a typical multi-family residential building located in Niš, Serbia (the third-largest urban center in the country), is discussed in this paper. This building was initially designed as a five-story CM structure in accordance with the 1981 Yugoslav seismic design code PTN-S, which was enforced in Serbia until 2019, when the Eurocode was adopted for official seismic design codes. Due to architectural constraints, the original design solution involving the CM system was not compliant with the code; hence, an alternative design using an RC-frame system with masonry infills was adopted. A comparison of two different design solutions provides insight into the different requirements of seismic design codes that have been used in the region. It is important to observe that seismic forces for RC structures determined in accordance with the PTN-S code are considerably lower compared to the ones determined according to EC 8-1, with the ratio ranging from 0.37 to 0.69. The seismic shear force according to Eurocode 8 is 1.46 times higher than the force that was used for seismic design according to the PTN-S code in the case of RC-frame structures. The results of an analysis of CM structures show that the seismic shear force in accordance with Eurocode 8 is almost 2.6 times higher than the force that was used for seismic design in accordance with the PTN-S code. The findings of this study are believed to be useful for understanding the difference in seismic design solutions for previous seismic design codes (which were used in the region for more than 40 years) and the present codes (Eurocodes).

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.