0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

Modeling of Traffic Noise along Urban Arterials in Irbid City of Jordan

Auteur(s):
Médium: article de revue
Langue(s): anglais
Publié dans: Jordan Journal of Civil Engineering, , n. 2, v. 18
DOI: 10.14525/jjce.v18i2.14
Abstrait:

Traffic-related noise pollution is a recurring problem in large and medium-sized cities. The objective of this study is to quantify traffic-noise levels along selected urban arterials and model the generated traffic noise based on traffic and pavement characteristics. Urban arterial and collector streets in Irbid city, Jordan, were taken as a case study. The city is considered an example of a medium-sized city. 65 urban arterial and collector sections were selected to achieve the stated objective. For each section, ten noise measurements were taken using a time interval of 2.5 minutes for each observation. The statistical pass-by method was used to measure 650 externalnoise observations. In addition, data on traffic, pavement and section geometric characteristics was obtained through field measurements. The collected traffic characteristics, including traffic flow, percentage of trucks and speed in each direction of travel, were obtained. In addition to the measurement of pavement macrotexture depth, an international roughness index was measured using a smartphone application. Investigation of the collected noise data indicated that urban streets experienced high noise levels, reaching maximum and average values of 82 and 77.2 dB(A), respectively. The results of the analyses showed that an increase in each of the included traffic characteristics resulted in significantly higher noise levels. For example, an increase in speed from 35 to 55 km/h would increase noise by 2.7 dB(A). In addition, the interaction term of roughness index and pavement macrotexture depth was found to increase the generated noise. Finally, the results of the analysis indicated that both multivariate linear -and exponential-regression models are suitable to model the generated traffic noise. Each model explained approximately 54% of the noise variability. Probably, traffic composition and vehicle-power type heterogeneity might reduce the level of explained variability. Keywords: Traffic noise, Urban arterials, Pass-by method, Noise modeling, Jordan.

Structurae ne peut pas vous offrir cette publication en texte intégral pour l'instant. Le texte intégral est accessible chez l'éditeur. DOI: 10.14525/jjce.v18i2.14.
  • Informations
    sur cette fiche
  • Reference-ID
    10773029
  • Publié(e) le:
    29.04.2024
  • Modifié(e) le:
    29.04.2024
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine