^ The Measurements of the elastic modulus of pavement subgrade layers using the SASW and FWD test methods | Structurae
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil


The Measurements of the elastic modulus of pavement subgrade layers using the SASW and FWD test methods


Médium: article de revue
Langue(s): anglais
Publié dans: The Baltic Journal of Road and Bridge Engineering, , n. 2, v. 10
Page(s): 174-181
DOI: 10.3846/bjrbe.2015.22

In pavement management systems, deflection basin tests, such as the Falling Weight Deflectometer test, are common techniques that are widely used, while the surface wave test, i.e. the Spectral Analysis of Surface Wave test, is recently employed as an alternative technique in pavement evaluation and monitoring. In this paper, the performance of both dynamic non-destructive tests on pavement subgrade investigation is presented. Surface wave propagation between a set of receivers was transformed into the frequency domain using the Fast Fourier Transform technique and subsequently a phase spectrum was produced to measure the time lag between receivers. Using the phase difference method, an experimental dispersion curve was generated. Inversion analysis based on the 3-D stiffness matrix method was then performed to produce a shear wave velocity profile. The elastic modulus of pavement layers was calculated based on linear elastic theory. In the Falling Weight Deflectometer test, seven geophones were used to collect in situ deflection data. Based on a back-calculation procedure with the ELMOD software, the elastic modulus of each flexible pavement layer can be obtained. Both techniques are able to comprehensively investigate the elastic modulus of the subgrade layer in existing pavement non-destructively. The elastic modulus between the Spectral Analysis of Surface Wave method and the Falling Weight Deflectometer test on the subgrade layer is observed to be in a good agreement. A correlation of the elastic modulus of thesubgrade layer from both techniques is also presented.

Structurae ne peut pas vous offrir cette publication en texte intégral pour l'instant. Le texte intégral est accessible chez l'éditeur. DOI: 10.3846/bjrbe.2015.22.
  • Informations
    sur cette fiche
  • Reference-ID
  • Publié(e) le:
  • Modifié(e) le: