0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

Laboratory Study on Changes in Gas Desorption Properties of Anthracite after Cyclic Loading

Auteur(s): ORCID


ORCID
ORCID
Médium: article de revue
Langue(s): anglais
Publié dans: Advances in Civil Engineering, , v. 2021
Page(s): 1-11
DOI: 10.1155/2021/7714303
Abstrait:

Coal mass is subjected to cyclic loading during pulsating hydraulic fracturing (PHF), and changes in its gas desorption properties affect gas drainage. Therefore, it is of great importance to correctly understand the influences of cyclic loading on the gas desorption properties of coal mass. Firstly, loading tests with different frequencies and amplitudes were performed on anthracite from Qinshui Basin (Shanxi Province, China) using a fatigue testing machine. Secondly, gas desorption tests were performed to determine the associated curves for each test group at different equilibrium pressures, and the initial desorption capacity and diffusion coefficient of the gas were calculated. Finally, the influence of different loading conditions on the gas desorption laws were analyzed. The test results demonstrate that a greater loading frequency increases the ratio of the initial desorption capacity so that the desorption rate of coal samples is higher, and the gas desorption properties become increasingly better in the initial stage. However, variations in the amplitude have minimal impact on the ratio of the initial desorption capacity. When the amplitude is too large in the initial stage, the diffusion coefficient decreases and the gas desorption properties worsen. In addition, the above test results are used to discuss the selection of the amplitude and frequency in the PHF process from a macroperspective. The contained research results provide an important theoretical basis for the field application of PHF technologies in coal mines.

Copyright: © Tie Li et al.
License:

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.

  • Informations
    sur cette fiche
  • Reference-ID
    10648163
  • Publié(e) le:
    10.01.2022
  • Modifié(e) le:
    17.02.2022
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine