0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

Hydration behaviour of limestone-calcined clay and limestone-slag blends in ternary cement

Auteur(s):

Médium: article de revue
Langue(s): anglais
Publié dans: RILEM Technical Letters, , v. 6
Page(s): 17-24
DOI: 10.21809/rilemtechlett.2021.134
Abstrait:

The effect of kaolinitic calcined clay and slag on the hydration of limestone-containing ternary blended cements was investigated. The effect of alumina from different sources of SCMs was considered to activate the formation of carboaluminates. Ternary blends with 50% ordinary portland cement clinker, 45% blends of limestone calcined clay (LC2) in 1:2 blend and slag limestone blend (SLS) in 2:1 mix proportion with 5% of gypsum were studied. The hydration behaviour was analysed based on cement mortar compressive strength, heat of hydration using an isothermal calorimeter and bound water measured using thermal gravimetric analysis (TGA). In addition, the degree of hydration of clinker phases and the composition of calcium - alumino - silicate - hydrate (C-A-S-H) gels forming in two different systems were compared on 90 days hydrated samples analysed using X-Ray diffractometry (XRD) and scanning electron microscopy - energy dispersive X-ray spectroscopy (SEM-EDX) respectively. The results show a rapid early strength development in limestone calcined clay cement blend (LC3) but a lower clinker hydration in comparison with slag limestone cement blend (SLSC) at later ages. In both the cement blends the formation of hemicarboaluminate (Hc) and monocarboaluminate (Mc) was confirmed at 90 days, but the conversion of Hc to Mc was higher in SLSC. Results further confirmed a lower degree of hydration and higher alumina incorporation in the C-A-S-H gel in the LC3 comparison to SLSC. The presence of calcium hydroxide was also confirmed in the SLSC blend due to the hydraulic nature of slag that supported the later age conversion of Hc to Mc as not seen in LC3.

Copyright: © 2021 Anuj Parashar, Shashank Bishnoi
License:

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.

  • Informations
    sur cette fiche
  • Reference-ID
    10603692
  • Publié(e) le:
    17.04.2021
  • Modifié(e) le:
    02.06.2021
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine