0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

Geosynthetic Reinforced Fill Material for Tennessee Bridge Approach Slab Support

Auteur(s): ORCID

ORCID
ORCID
Médium: article de revue
Langue(s): anglais
Publié dans: Transportation Research Record: Journal of the Transportation Research Board, , n. 12, v. 2675
Page(s): 142-160
DOI: 10.1177/03611981211028607
Abstrait:

The approach slab is constructed at bridge ends to serve as a smooth transition from the highway pavement to the bridge deck. However, motorists usually complain about a sudden change in elevation (bump) at the highway/approach slab (H/S) joint that causes a potential hazard for public safety, damage to vehicles, and rider discomfort. This paper develops a finite element (FE) analysis for the differential settlement at the H/S joint when supported by a strip footing that sits on compacted layers of soil embankment with uniaxial geogrid reinforcement. A parametric study was conducted to select the optimum design that consists of five geogrid layers equally spaced within a depth of 2 [Formula: see text] below the strip footing, where [Formula: see text] is the width of the footing. The inclusion of geogrid reinforcement did not only enhance the ultimate bearing stress of the strip footing but also redistributed the vertical loads over a wider region of soil embankment and thus reduced settlement. A case study is also presented for modeling the performance of a preliminary design proposed by Tennessee Department of Transportation (TDOT) for the retrofit of bridge ends. The FE analysis showed a 30%–40% improvement in the ultimate bearing stress of the strip footing when the geogrid reinforcement proposed by TDOT is extended to a depth of 1.5 [Formula: see text] below the footing.

Structurae ne peut pas vous offrir cette publication en texte intégral pour l'instant. Le texte intégral est accessible chez l'éditeur. DOI: 10.1177/03611981211028607.
  • Informations
    sur cette fiche
  • Reference-ID
    10777901
  • Publié(e) le:
    12.05.2024
  • Modifié(e) le:
    12.05.2024
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine