0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

Experimental Study on External Loading Performance of Large Diameter Prestressed Concrete Cylinder Pipe

Auteur(s): ORCID



ORCID
ORCID
Médium: article de revue
Langue(s): anglais
Publié dans: Buildings, , n. 10, v. 12
Page(s): 1740
DOI: 10.3390/buildings12101740
Abstrait:

A prestressed concrete cylinder pipe (PCCP) is created with a complex composition of concrete core, welded steel cylinder, prestressed steel wire, protective mortar and anti-corrosion coating. Due to the economy and complexity of structural prototype tests, the ultimate loading test on PCCP is rarely conducted. In this paper, the three-edge bearing test was carried out on a 3.2 m diameter PCCP with embedded steel cylinder. The strains of concrete core, prestressed steel wire and protective mortar were monitored, and the distribution and width of the concrete cracks were recorded. The test results show that the cracking on the inside concrete at the crown zone occurred before those on the invert zone of the pipe. The prestressed steel wire postponed the tensile stress of out-side concrete at the springing line until subjected to the calculated cracking load (Pc). Due to the moment redistribution caused by the cracking on the inside of the concrete at the crown/invert, the protective mortar at the springing line was cracked at 1.2 Pc and exhibited visible cracking after 1.4 Pc. The prestressed steel wire reached the elastic and strength limit states of 1.4 Pc and 1.6 Pc, respectively. The PCCP designed by the limit state design method can resist the increased external loads after reaching the serviceability limit state. The final failure load of the test pipe is greater than 1.6 Pc, and there is sufficient safety in actual operation. Due to the fact that the damage to the concrete at the crown/invert zone may become a fuse of PCCP failure, the tensile stress of the inside concrete at the crown/invert zone of the PCCP should be accurately verified in the design process.

Copyright: © 2022 by the authors; licensee MDPI, Basel, Switzerland.
License:

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.

  • Informations
    sur cette fiche
  • Reference-ID
    10700033
  • Publié(e) le:
    11.12.2022
  • Modifié(e) le:
    15.02.2023
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine