Effect of Dry-wet Cycle on the Formation of Loess Slope Spalling Hazards

This paper investigates the effect of dry-wet cycle process on the formation of loess slope spalling hazards. Based on the CT scan tests and macroscopic fissures analysis, the fissure variation law of loess samples under different dry-wet cycle times were determined. Through the laboratory direct shear tests, the variation law of shear strength, cohesion and angle of internal friction of loess samples under different dry-wet cycle times and different dry-wet cycle water content variation ranges were discussed. The results show that the natural water contents of Luo-chuan loess were higher than Tong-chuan loess due to it’s higher contents of clay particles. With the increase of dry-wet cycle times, the internal fissure numbers of loess samples increased dramatically. The value of shear strength and cohesion of loess samples in two different areas decreased dramatically due to the increase of dry-wet cycle times. Higher water content variation ranges of dry-wet cycles leaded to lower shear strength of loess samples under the same dry-wet cycle times. Loess slope spalling hazards often happened due to the decrease of shear strength and the occurrence of internal fissures in loess induced by the dry-wet cycle process.

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.