0
  • DE
  • EN
  • FR
  • Base de données et galerie internationale d'ouvrages d'art et du génie civil

Publicité

A Comparison Between Inclined Shear Reinforcement and Loop Shear Reinforcement on RC Beam: Finite Element Approach

Auteur(s):




Médium: article de revue
Langue(s): anglais
Publié dans: Malaysian Journal of Civil Engineering, , n. 3, v. 33
DOI: 10.11113/mjce.v33.17307
Abstrait:

In this present study, a numerical analysis has been performed to compare the shear resisting capacities between beams with conventional loop stirrup and inclined stirrup. Resisting the shear force is one of the key features of stirrups. A rarely used and uncommon inclined stirrup setup is analyzed in this study and new findings are compared with the results of loop stirrup. Two sets of beams (150x300x1960mm) are analyzed to determine the ultimate shear force resisting capacities, displacement, and stress resistance capacities. It was observed that the beam with an inclined stirrup showed ultimate shear resistance up to 187.24 KN compared to the beam with a loop stirrup setup which was 114.24 KN.  Displacement of the inclined stirrup setup and the loop stirrup setup was 2.38 mm and 4.21 mm. Stress resistance and distribution pattern was also improved upon using inclined stirrup. Flexural and Shear Crack patterns of the beams at the ultimate load are also predicted from numerical analysis. Numerical study has been carried out by using Finite Element Software ABAQUS. Finally, these results were also compared with the theoretical formula available in the literature to justify the numerical analysis.

Structurae ne peut pas vous offrir cette publication en texte intégral pour l'instant. Le texte intégral est accessible chez l'éditeur. DOI: 10.11113/mjce.v33.17307.
  • Informations
    sur cette fiche
  • Reference-ID
    10747210
  • Publié(e) le:
    07.12.2023
  • Modifié(e) le:
    07.12.2023
 
Structurae coopère avec
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine