Cement Slurry Plugging Law and Optimal Plugging Flow Rate at a High Hydraulic Gradient

With the continuous development of coal and rock mass engineering, water inrush grouting has become an urgent problem in engineering disaster management. Herein, a theoretical model of the optimal plugging flow rate was established, and a comparative theoretical analysis was performed based on the results of indoor model tests. The particle incipient velocity was defined as the optimal plugging flow rate. The effects of hydrodynamic velocity, water-cement ratio, grouting pressure, and fracture aperture on the cement slurry grouting plugging were studied, and the optimal threshold of the plugging flow rate was obtained for theoretical model verification. Results showed that, at a high hydraulic gradient, the plugging effect of the grout was mainly affected by the hydrodynamic velocity, water-cement ratio, and grouting pressure (listed in the order of importance). When the hydrodynamic velocity was low, the difference in the slurry deposition thickness was large under different water–cement ratios and pipe diameters. When the hydrodynamic velocity was increased, the influence of various factors on the slurry deposition thickness decreased. Through a comparative analysis of the experimental and theoretical values, the optimal plugging velocity of pure cement slurry was 0.5–0.55 m·s−1 under different conditions, and the error between the experimental and theoretical values was less than 0.1 m·s−1, which confirmed the rationality of the proposed model.

Cette oeuvre a été publiée sous la license Creative Commons Attribution 4.0 (CC-BY 4.0). Il est autorisé de partager et adapter l'oeuvre tant que l'auteur est crédité et la license est indiquée (avec le lien ci-dessus). Vous devez aussi indiquer si des changements on été fait vis-à-vis de l'original.