0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Three-Dimensional Aerodynamic Optimization of Single-Layer Reticulated Cylindrical Roofs Subjected to Mean Wind Loads

Autor(en):


Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Advances in Civil Engineering, , v. 2019
Seite(n): 1-13
DOI: 10.1155/2019/4156319
Abstrakt:

This paper presents a procedure to optimize the rise-to-span ratio of single-layer reticulated cylindrical roofs to improve their aerodynamic performance, by coupling the optimization method with computational fluid dynamics (CFD) and finite element analysis (FEA). Four turbulence models (standardk-ε, RNGk-ε, SSTk-ω, and RSM) were used to predict the mean wind loads on cylindrical roofs. The simulation results were compared with wind tunnel data, and the RSM turbulence model was employed. The aim of this paper is to determine the best performing rise-to-span ratio of cylindrical roofs based on the gradient algorithm. Two objective functions were considered to minimize the highest mean suction on the roof surface and the maximum response displacement of the single-layer reticulated cylindrical shell subjected to mean wind loads. The results revealed that a cylindrical roof with a rise-to-span ratio (R/S) of 1/6.25 seems to be most effective in attenuating high suctions on the roof surface. In addition, a single-layer reticulated cylindrical shell withR/S = 1/5.5 gives the best performance in reducing the maximum response displacement against wind loads.

Copyright: © Bingbing San et al.
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10365044
  • Veröffentlicht am:
    24.08.2019
  • Geändert am:
    02.06.2021
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine