Stabilization of Different Soil Types Using a Hydraulic Binder

This paper presents an analysis of the stabilization of different soil types using a hydraulic binder. A study was carried out on soils that can be classified into two groups: cohesive and non-cohesive soils. Clay soils of medium and low plasticity according to the USCS classification were used as cohesive materials, while the sandy material containing dust was considered as non-cohesive material. Samples were taken from fifteen locations in Vojvodina province, Serbia. A hydraulic binder was used as a binder based on cement and lime. The amounts of the binder were estimated at 3, 5, 7, and 9%. In order to determine the basic physical and mechanical characteristics of the specimens, the following tests were performed: unconfined compressive strength after 7 and 28 days, indirect tensile strength after 7 and 28 days, as well as the California Bearing Ratio. Based on the obtained results, it can be concluded that increasing the amount of binder results in an increase in the subgrade load-bearing capacity. However, it should be emphasized that the subgrade containing non-cohesive material had a lower growth in the load-bearing capacity than those with the cohesive material.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.