Reproducing Field Measurements Using Scaled-Down Hydraulic Model Studies in a Laboratory

Little efforts have been made to the value of laboratory model study in closing the gap between results from idealized laboratory experiments and those from field data. Thus, at first, three bridge sites were selected and equipped with fathometers to find the bed elevation change in the vicinity of bridge pier over time. After and during the flooding, the stream flow variables and their bathymetry were measured using current viable technologies at the field. Then, to develop and suggest a laboratory modeling techniques, full three-dimensional physical models including measured river bathymetry and bridge geometry were designed and fabricated in a laboratory based on the scale ratio except for the sediment size, and the laboratory results were compared with the field measurements. Size of uniform sediment was carefully selected and used in the laboratory to explore the scale effect caused by sediment size scaling. The comparisons between laboratory results and field measurements show that the physical models successfully reproduced the flow characteristics and the scour depth around bridge foundations. With respect to the location of the maximum scour depth, they are not consistent with the results as in the previous research. Instead of occurring at the nose of each pier, the maximum scour depths are located further downstream of each pier column in several experimental runs because of the combination of complex pier bent geometry and river bathymetry, and the resulting unique flow motions around the pier bent.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.