Recyclability, durability and water vapour adsorption of unstabilised and stabilised compressed earth bricks

This paper investigates the recyclability, liquid water durability and water vapour adsorption of both unstabilised and stabilised compressed earth bricks. Stabilised bricks were manufactured by adding either cement or the biopolymer guar gum to the base earth. Unconfined compressive strength tests were then performed on both unstabilised and stabilised earth bricks manufactured with recycled material (i.e. material taken from the failed compressed earth bricks after the compressive strength tests). These tests enabled to assess the influence of recycling on the stiffness, strength and strain energy of all compressed earth bricks. Immersion and drip tests were subsequently performed to investigate the effect of cement and biopolymer stabilisation on the durability of the compressed earth bricks against the weathering action of water. An additional set of laboratory experiments was finally conducted by means of a Dynamic Vapour Sorption (DVS) system to study the effect of earth stabilisation on the capacity of adsorbing/releasing water vapour as the ambient humidity changes. Outcomes from this experimental campaign showed that both unstabilised and biopolymer stabilised earth bricks maintained a similar mechanical performance after recycling, while cement stabilised bricks showed a remarkable reduction of both stiffness and strength. Finally, both cement and biopolymer stabilised bricks improved the liquid water durability while reducing the water vapour adsorption compared with the unstabilised earth bricks. Results from this experimental work will be useful for life cycle assessments, especially for modelling the end-of-life of the material as well as its potential reuse.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.