Parametric Modeling and Numerical Simulation of a Three-Dimensional Random Aggregate Model of Lime–Sand Piles Based on Python–Abaqus

A lime–sand pile is a three-phase particle composite material composed of a lime matrix, sand, and a loess aggregate at the meso level. Establishing a random aggregate model that can reflect the actual aggregate gradation, content, and morphology is the premise of numerical simulations of the meso-mechanics of lime–sand piles. In this paper, the secondary development of Abaqus 2022 is realized by writing Python 3.12 scripts, and a parameterized three-phase mixed lime–sand pile random meso-spherical aggregate model is obtained. A meso-modeling idea of lime–sand piles is creatively proposed, the integrated-generation algorithm of a spherical aggregate of different materials is written, and the material’s properties and mesh generation are given by the algorithm. Finally, a numerical simulation of temperature–expansion statics is carried out using an established mesoscopic model. Under different mixing ratios, the expansion force increases with an increase in the lime proportion. The increase in the expansion force is approximately 45% of that without an increased lime proportion. The simulated expansion forces are 8.81 kN, 12.61 kN, and 18.89 kN, respectively, which are similar to the experimental results for laboratory specimens, and the relative error is less than 3%. In the case of different height ratios, with increases in height, the change in the expansion force is very small, and the relative error between the simulated value and the experimental value is less than 2%, which further verifies the reliability of the mesoscopic random model of lime–sand piles. The model can be used to guide the practical application of engineering.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.