Optimization of All-Desert Sand Concrete Aggregate Based on Dinger–Funk Equation

In recent years, with the development of the construction industry and the wide application of concrete materials, the demand for natural resources such as sand and gravel in China has continued to grow. The Xinjiang region is rich in natural desert sand resources due to its large desert area, which are inexpensive and easy to obtain, providing new possibilities for the production of concrete materials. The use of natural desert sand as concrete aggregate not only reduces the cost of construction but also contributes to the protection of the environment and the rational development and utilization of natural resources. However, poor particle gradation in natural desert sand leads to poor concrete properties. In this study, the Dinger–Funk equation was used to optimize the aggregate gradation of natural desert sand from Toksun, Xinjiang, and concrete specimens were prepared for mechanical properties and sulfate erosion resistance tests. The test results show that the four groups of aggregates optimized by the Dinger–Funk equation are better than the single gradation and natural gradation in terms of apparent density, bulk density, void ratio, mechanical properties, and durability of concrete. Where the distribution modulus n = 0.3 was the best, the compressive strength, splitting strength, and flexural strength were increased by 13.14%, 15.71%, and 11.08%, respectively, as compared to the natural gradation. After 90 sulfate erosion and dry–wet cycles, the mass change rate and relative dynamic elastic modulus of concrete specimens first increased and then decreased, and at the distribution modulus n = 0.3, the aggregate particles of 0.3–0.6 mm, 0.6–1.18 mm, and 1.18–2.36 mm accounted for 26.98%, 32.33%, and 40.69%, respectively, and the smallest of the mass change rates of durability was the best.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.