Laboratory and Environmental Assessment of Asphalt Mixture Modified with a Compound of Reclaimed Asphalt Pavement and Waste Polyethylene

The use of reclaimed asphalt pavement (RAP) in manufacturing asphalt concrete has become indispensable all over the world. This is due to the limited number of areas that are required to stockpile scraped pavement, as well as a lack of natural aggregate, which is necessary in manufacturing asphalt concrete. Thus, this research aims to evaluate the mechanical characteristics and environmental impact of using RAP and waste polyethylene in hot mix asphalt (HMA). RAP was added to hot mix asphalt in proportions of 25%, 50%, 75%, and 100% instead of the same amount of coarse aggregate. Then, the optimum RAP hot mix asphalt was modified by adding polyethylene in proportions of 1%, 2%, 3%, and 4% into the hot mix asphalt. The Marshall mix design was used to define the optimum asphalt content. As a final point in this experimental work, tests on the loss of stability, indirect tensile strength, and wheel loading tracking were performed to assess the performance of asphalt mixes modified with RAP and polyethylene in different conditions. A life cycle assessment (LCA) was applied using the ReCipe 2016 Endpoint method to evaluate the environmental impacts of these mixtures using the SimaPro software, V9.1. The laboratory tests showed that the mixture containing 50% RAP instead of the same amount of coarse aggregate and 2% polyethylene recorded better Marshall characteristics than the control mixture and the mixture with RAP alone. Finally, the modified hot mix asphalt with added RAP and polyethylene not only achieved superior performance in rutting, water damage resistance, and the stiffness modulus of bituminous mixtures, but it has been verified that there is no serious risk to the environment.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.