0
  • DE
  • EN
  • FR
  • Internationale Datenbank und Galerie für Ingenieurbauwerke

Anzeige

Crack Characteristic and Permeability Change of Compacted Clay Liners with Different Liquid Limits under Dry-Wet Cycles

Autor(en):



Medium: Fachartikel
Sprache(n): Englisch
Veröffentlicht in: Advances in Civil Engineering, , v. 2018
Seite(n): 1-9
DOI: 10.1155/2018/5796086
Abstrakt:

The crack characteristic and permeability change in six compacted clay liners (CCLs) under dry-wet cycles were studied. Results show that as soil liquid limit (LL) increases, the crack block (CB) number, crack ratio (CR), and crack length (CL) of the CCLs increase under the dry state. The CB sizes of all the six CCLs correspond to normal distribution. A piecewise linear relationship exists between crack parameters and soil LL, and the slope at LL< 50 is larger than the slope at LL >50. The size of the representative elementary volume (REV) of cracked CCL decreases linearly with the increase in soil LL when LL< 50. The linear fitting result is REV = 90.5 – 1.6 LL, whereas REV change is inconspicuous with a mean value of approximately 10 cm when LL >50. The sample size of the CCLs for the permeability test must be larger than REV. Before and after three dry-wet cycles, the permeability ratio (K3/k0) initially increases and eventually decreases as soil LL increases, and LL at the peak value ofK3/k0is 36.1%. However, linear relationships exist between permeability D-value (K3 − k0) and soil LL in a semilog coordinate system when LL< 50%, whereas the change in the permeability D-value is inconspicuous with a mean value of approximately 1.67 × 10−8 cm/s when LL >50%. The volume and mean width of unclosed cracks are two main factors that determine the increase in permeability after dry-wet cycles. After three dry-wet cycles, these factors decrease as soil LL increases, thereby reducing the permeability D-value.

Copyright: © 2018 Yong Wan et al.
Lizenz:

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.

  • Über diese
    Datenseite
  • Reference-ID
    10222706
  • Veröffentlicht am:
    01.12.2018
  • Geändert am:
    02.06.2021
 
Structurae kooperiert mit
International Association for Bridge and Structural Engineering (IABSE)
e-mosty Magazine
e-BrIM Magazine