Experimental and Numerical Study of Welding Residual Stress Distribution in Shear Keys
|
|
|||||||||||
Bibliografische Angaben
| Autor(en): |
Junhui She
(Key Laboratory of Performance Evolution and Control for Engineering Structures (Ministry of Education), Tongji University, Shanghai 200092, China; Department of Structural Engineering, Tongji University, Shanghai 200092, China)
Tao Chen (Key Laboratory of Performance Evolution and Control for Engineering Structures (Ministry of Education), Tongji University, Shanghai 200092, China; Department of Structural Engineering, Tongji University, Shanghai 200092, China) Kelei Ni (Key Laboratory of Performance Evolution and Control for Engineering Structures (Ministry of Education), Tongji University, Shanghai 200092, China; Department of Structural Engineering, Tongji University, Shanghai 200092, China) |
||||
|---|---|---|---|---|---|
| Medium: | Tagungsbeitrag | ||||
| Sprache(n): | Englisch | ||||
| Tagung: | IABSE Congress: Bridges and Structures: Connection, Integration and Harmonisation, Nanjing, People's Republic of China, 21-23 September 2022 | ||||
| Veröffentlicht in: | IABSE Congress Nanjing 2022 | ||||
|
|||||
| Seite(n): | 821-827 | ||||
| Anzahl der Seiten (im PDF): | 7 | ||||
| DOI: | 10.2749/nanjing.2022.0821 | ||||
| Abstrakt: |
Welding technologies are widely applied in all kinds of steel structures. No matter what kind of welding is used, the welding residual stress is always inevitable. So, in this research, a semi- destructive experiment and a numerical simulation are conducted to study the welding residual stress distributions of shear keys in the grouted connection section. The experiment uses the blind hole method on 3 flat-plate specimens of the sleeve section, to measure the welding residual stress distributions of them, which gives an approximate distribution of the real grouted connection section. Based on the experiment, a FEM numerical simulation is performed to estimate welding residual stress distribution. During the numerical simulation, EBD (Element Birth and Death) and Dflux subroutine are applied to maintain a better precision. Through the experiment and simulation, a comparison is done and a good correlation between welding residual stresses was found. |
||||
| Stichwörter: |
Finite-Elemente-Methode (FEM) FEM Stahlbauwerk / -konstruktion
|
||||
| Copyright: | © 2022 International Association for Bridge and Structural Engineering (IABSE) | ||||
| Lizenz: | Die Urheberrechte (Copyright) für dieses Werk sind rechtlich geschützt. Es darf nicht ohne die Zustimmung des Autors/der Autorin oder Rechteinhabers/-in weiter benutzt werden. |
||||