An Economical Composite Girder Bridge Using Rolled Steel H-Section
|
|
|||||||||||
Bibliografische Angaben
| Autor(en): |
Mohammad Hamid Elmy
(Tokai University, Hiratsuka, Japan)
Shunichi Nakamura (Tokai University, Hiratsuka, Japan) |
||||
|---|---|---|---|---|---|
| Medium: | Tagungsbeitrag | ||||
| Sprache(n): | Englisch | ||||
| Tagung: | IABSE Congress: Challenges in Design and Construction of an Innovative and Sustainable Built Environment, Stockholm, Sweden, 21-23 September 2016 | ||||
| Veröffentlicht in: | IABSE Congress Stockholm, 2016 | ||||
|
|||||
| Seite(n): | 1964-1971 | ||||
| Anzahl der Seiten (im PDF): | 8 | ||||
| Jahr: | 2016 | ||||
| DOI: | 10.2749/stockholm.2016.1972 | ||||
| Abstrakt: |
The bridge using rolled steel H-section seems very economical compared with the welded plate girder bridges due to lower material and fabrication cost. On the other hand, as the maximum web height is 900 mm, the applicable span length of the girder bridge with rolled H-section is up to 20m or 25m. A new composite girder bridge was proposed using rolled steel H-section. The superstructure is a continuous girder with rolled steel H-section and the RC slab, and the substructure is RC pier. The girder and the pier are rigidly connected by concrete and reinforcements. This new SRC bridge is basically the multi-span rigid frame structure: the steel/concrete composite girder resists at the span-center, and the steel girder covered by RC section resists at the rigid joints. The proposed SRC bridge increases the span length up to 50m, and its construction cost is much lower than the conventional plate girder bridge. |
||||
| Stichwörter: |
experimentelle Untersuchung nichtlineare Analyse
|
||||
