The Width-Thickness Ratio Limits of Thin-Walled Steel Elements with Complex Edge Stiffeners

Complex edge stiffeners are widely used because of their superior performance over simple edge stiffeners in limiting flange buckling and improving local stability. However, most of the studies on complex edge stiffeners are qualitative. In this paper, the criterion to judge the stiffening adequacy based on the buckling half-wavelength and buckling coefficient is proposed. It is considered as the criterion that the edge stiffeners’ stiffness is not less than the minimum stiffening stiffness or the half-wavelength of buckling is not more than the width of the flange. The criterion is followed for the minimum limits of the edge stiffener width−thickness ratios; whether the flange buckling occurs before the edge stiffener buckling and the economic implications are the criteria that should be followed for the maximum limits of the edge stiffener width−thickness ratios. Using the finite strip method, the feasibility of the criteria was verified by comparing them with the rules of simple edge stiffeners. The detailed design requirements for the width−thickness ratio limits of thin-walled steel elements with complex edge stiffeners were first given from an extensive parametric analysis. Based on the optimization algorithm, the suggestions and optimum sizes of complex edge stiffeners for thin-walled steel elements are provided, considering the sections’ economy and performance. It is considered that a ratio of 1:1 between the primary and the secondary edge stiffeners’ widths is the best configuration for elements with complex edge stiffeners.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.