Torsional Stiffness Correction of the Split-Type Triple-Box Steel Box Girder Based on Refined Simulation

Split-type steel box girders are widely used in long-span bridges because of their good wind-resistance performance. In the design stage, a simple finite element model is usually established based on the beam element for wind-resistance design. However, since the irregular cross-beams and diaphragms in the split steel box girder cannot be virtually established, the stiffness of the girder will be underestimated. To improve the accuracy in simulating stiffness of the split-type triple-box steel box girder (STSBG) with the beam element model (BEM), a correction is made to the initial beam element model (IBEM) based on the result of a more refined finite element model. ANSYS is adopted to make a refined model (RM) of a bridge with STSBG as its girder and to calculate its aerostatic responses and dynamic characteristics in 3 typical construction states and 1 finished state. With the reference value, an objective function of the overall residual sum of squares is constructed for the torsion angle of the girder and the frequency of the bridge. Then, the beam element is used for conventional modelling of the bridge, and artificial bee colony (ABC) algorithm is adopted for the optimization and correction of structure parameters of the BEM of the girder. Finally, static and dynamic characteristics of the IBEM and the corrected beam element model (CBEM) are compared with values of the corresponding RM to evaluate the validity of the correction of the model. The results show that the aerostatic responses and dynamic characteristics of the CBEM are close to calculated values of the RM. In more detail, the relative error between the torsion angle of the girder in the middle span of the BEM and the corresponding reference value in the finished state is decreased from +61.71% to +4.94%, and the relative error of torsional fundamental frequency is decreased from −17.43% to +3.66%. According to the calculated value of the RM, ABC algorithm would satisfactorily improve the accuracy in simulating torsional stiffness of the STSBG with the IBEM. This research is expected to provide reference for beam element modelling, which is conducive to accurately simulating torsional stiffness of the STSBG.

Dieses Werk wurde unter der Creative-Commons-Lizenz Namensnennung 4.0 International (CC-BY 4.0) veröffentlicht und darf unter den Lizenzbedinungen vervielfältigt, verbreitet, öffentlich zugänglich gemacht, sowie abgewandelt und bearbeitet werden. Dabei muss der Urheber bzw. Rechteinhaber genannt und die Lizenzbedingungen eingehalten werden.